ATmega16 datasheet(266/357 Pages) ATMEL

266 / 357 page

266

2466S–AVR–05/09

ATmega16(L)

grammed simultaneously. The following procedure describes how to program the entire Flash

memory:

A. Load Command “Write Flash”

Set XA1, XA0 to “10”. This enables command loading.

Set BS1 to “0”.

Set DATA to “0001 0000”. This is the command for Write Flash.

Give XTAL1 a positive pulse. This loads the command.

B. Load Address Low byte

Set XA1, XA0 to “00”. This enables address loading.

Set BS1 to “0”. This selects low address.

Set DATA = Address Low byte ($00 - $FF).

Give XTAL1 a positive pulse. This loads the address Low byte.

C. Load Data Low Byte

Set XA1, XA0 to “01”. This enables data loading.

Set DATA = Data Low byte ($00 - $FF).

Give XTAL1 a positive pulse. This loads the data byte.

D. Load Data High Byte

Set BS1 to “1”. This selects high data byte.

Set XA1, XA0 to “01”. This enables data loading.

Set DATA = Data High byte ($00 - $FF).

Give XTAL1 a positive pulse. This loads the data byte.

E. Latch Data

Set BS1 to “1”. This selects high data byte.

Give PAGEL a positive pulse. This latches the data bytes. (See Figure 129 for signal

waveforms)

F. Repeat B through E until the entire buffer is filled or until all data within the page is loaded.

While the lower bits in the address are mapped to words within the page, the higher bits address

the pages within the FLASH. This is illustrated in Figure 128 on page 267. Note that if less than

8 bits are required to address words in the page (pagesize < 256), the most significant bit(s) in

the address Low byte are used to address the page when performing a page write.

G. Load Address High byte

Set XA1, XA0 to “00”. This enables address loading.

Set BS1 to “1”. This selects high address.

Set DATA = Address High byte ($00 - $FF).

Give XTAL1 a positive pulse. This loads the address High byte.

H. Program Page

Set BS1 = “0”

Give WR a negative pulse. This starts programming of the entire page of data. RDY/BSY

goes low.

Wait until RDY/BSY goes high. (See Figure 129 for signal waveforms)

I. Repeat B through H until the entire Flash is programmed or until all data has been

programmed.

ATmega16 датащи(PDF) 266 Page - ATMEL Corporation

ATmega16 датащи(HTML) 266 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL