• North America Tel: 800.366.2266 / Fax: 978.366.2266

• Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300

• Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298

Visit www.macomtech.com for additional data sheets and product information.

M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make

changes to the product(s) or information contained herein without notice.

4

Digital Attenuator, 5-Bit, 15.5 dB

500 - 2500 MHz

Rev. V2

MAATSS0022

ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions

is considering for development. Performance is based on target specifications, simulated results,

and/or prototype measurements. Commitment to develop is not guaranteed.

PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology

Solutions has under development. Performance is based on engineering tests. Specifications are

typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available.

Commitment to produce in volume is not guaranteed.

Lead-Free MSOP-10

†

Handling Procedures

Please observe the following precautions to avoid

damage:

Static Sensitivity

Gallium Arsenide Integrated Circuits are sensitive

to electrostatic discharge (ESD) and can be

damaged by static electricity. Proper ESD control

techniques should be used when handling these

devices.

†

Reference Application Note M538 for lead-free solder reflow recommendations.

Meets JEDEC moisture sensitivity level 1 requirements.

Operating Instructions

The MAATSS0022 is designed to operate with 5 V

logic levels. The difference between +3 V and +5

V operation is minimal for small signal perform-

ance. IIP3, however, is a strong function of volt-

age.

+3 V is the minimum voltage at which the

product will reliably operate.

The MAATSS0022 requires a parallel interface that

allows the user to enter a 5 bit digital word. Each

state increments the attenuation by 0.5 dB giving a

total range of 15.5 dB.

The MAATSS0022 is not internally DC blocked.

This means that the device requires DC blocking

capacitors on the RF1 and RF2 ports. M/A-COM

recommends 0.1 uF to allow for the entire fre-

quency range to be utilized.

Higher frequency

applications can use smaller value capacitors as

DC blocks.

For application information concerning this and

other M/A-COM products, please visit our website

at www.macom.com, where information including

soldering profiles, reliability procedures, and S-

parameter data can be found.