AP3703 datasheet(8/11 Pages) BCDSEMI

8 / 11 page

LOW-POWER OFF-LINE PRIMARY SIDE REGULATION CONTROLLER

AP3703

Preliminary Datasheet

BCD Semiconductor Manufacturing Limited

Feb. 2009 Rev. 1.0

Operation Description (Continued)

where the Vd is the diode forward drop voltage.

The output voltage is different from the secondary

voltage in a diode forward drop voltage that depends

on the current. If the secondary voltage is always

detected at a fixed secondary current, the difference

between the output voltage and the secondary voltage

will be a fixed Vd. For AP3703, the voltage detection

point is at two-thirds of the D1 on-time, which means

the the secondary voltage is detected at a fixed

secondary current of one-third of Ipks. The CV loop

control function of AP3703 then generates a D1 off-

time to regulate the output voltage.

Constant Current Operation

Figure 10 shows the secondary current waveforms.

In CC operation, the CC loop control function of

AP3703 will keep a fixed proportion between D1 on-

time Tons and D1 off-time Toffs by discharging or

charging a capacitor embedded in the IC. The fixed

proportion is:

The relationship between the output constant-current

and secondary peak current Ipks is given by:

At the instant of D1 turn-on, the primary current

transfers to the secondary at an amplitude of:

Thus the output constant-current is given by:

Leading Edge Blanking

When the power switch is turned on, a turn-on spike

will occur on the sense-resistor. To avoid false-

termination of the switching pulse, a 430ns leading-

edge blanking is built in. During this blanking period,

the current sense comparator is disabled and the gate

driver can not be switched off.

CCM Protection

The AP3703 is designed to operate in discontinuous

conduction mode (DCM) in both CV and CC modes.

To avoid operating in continuous conduction mode

(CCM), the AP3703 detects the falling edge of the FB

input voltage on each cycle. If a 0.1V falling edge of

FB is not detected, the AP3703 will stop switching.

OVP & OCkP

The AP3703 includes output over-voltage protection

(OVP) and open circuit protection (OCkP) circuitry as

shown in Figure 11. If the voltage at FB pin exceeds

8V, 100% above the normal detection voltage, or the

-1.5V falling edge of the FB input can not be

monitored, the AP3703 will immediately shut off and

enters hiccup mode. The AP3703 sends out a fault

detection pulse every 24ms in hiccup mode until the

fault has been removed.

Figure 9. Auxiliary Voltage Waveform

See equation 8

Tons

Toffs

Iout

Figure 10. Secondary Current Waveform

Toffs

Tons

......(6)

Toffs

Tons

Ipks

Iout

......(7)

Ipk

Ipks

......(8)

Ipk

Toffs

Tons

Ipk

Iout

......(9)

See equation 5

Tons

2/3 Tons

AP3703 датащи(PDF) 8 Page - BCD Semiconductor Manufacturing Limited

AP3703 датащи(HTML) 8 Page - BCD Semiconductor Manufacturing Limited

Html Pages

1 2 3 4 5 6 7 8 9 10 11

датащи скачать

ссылки URL