Description

The Remote Printer Interface (RPI) Module provides a parallel

printer interface to allow any 600 Series FACP to communicate

with and supervise a printer for logging system activity.

Printers can be used to log both testing and real life system

status whenever a hard copy record is required. The RPI’s

parallel output makes supervised communication with virtually

any printer simple. The RPI is also capable of monitoring “off

line”, “paper out” and “no communications” conditions at the

printer.

The combination of any Remote Annunicator (RAN), Serial

Annunciator Drive or Remote Printer Interface (RPI) make up

the Gamewell Status Control Network.

The Status Control Network including RPI units is connected

to the main 600 Series control panel via an RS-232 data

communication line. The SIM-232 module is used to provide

an isolated RS-232 output from the main CPU of the 620, 630,

632, and 650 system panels. The IF610 comes with its own

built-in RS-232 port.

RPI

600 Series

Remote Printer

Interface

Features

• Standalone Wall or Desk Mount

• Supervised

• Parallel Printer Compatible

• Up to 64 Devices Supported on a Single 600 Series FACP

• Dual Optically Isolated Serial Ports

• Microprocessor based

• Supervised

RPI

Specifications

Remote Printer Interface

RPI

Input Power:

24 VAC/VDC

Quiescent Current:

.040A

Alarm Current:

.040A

Dimensions:

12.5”Wx5”H x 2.25”D

Mounting:

Wall or Desk

CS-2028

09/01/06

Gamewell-FCI

Tel: (203) 484-7161

12 Clintonville Road

FAX: (203) 484-7118

Northford, CT 06472

www.gamewell-fci.com

©Gamewell-FCI 2006

Specifications and wiring information are provided for information only and are believed to be accurate. Gamewell-FCI assumes no

responsibility for their use. Data and design are subject to change without notice. Installation and wiring instructions shipped with the

product shall always be used for actual installation. For more information, contact Gamewell-FCI.

Ordering Information

Part Number

Description

RPI

Remote Printer Interface Module

SIM-232

Serial Interface Module

70703

Programming Cable

(Note: Programmed via a

Windows-based program “SAN

Program” included in Smart

Program 7.1 CD

- Part Number SP7-CD)