CDC2510C

3.3-V PHASE-LOCK LOOP CLOCK DRIVER

SCAS621 – DECEMBER 1998

3

POST OFFICE BOX 655303

Terminal Functions

TERMINAL

TYPE

DESCRIPTION

NAME

NO.

TYPE

DESCRIPTION

CLK

24

I

Clock input. CLK provides the clock signal to be distributed by the CDC2510C clock driver. CLK is

used to provide the reference signal to the integrated PLL that generates the clock output signals. CLK

must have a fixed frequency and fixed phase for the PLL to obtain phase lock. Once the circuit is

powered up and a valid CLK signal is applied, a stabilization time is required for the PLL to phase lock

the feedback signal to its reference signal.

FBIN

13

I

Feedback input. FBIN provides the feedback signal to the internal PLL. FBIN must be hardwired to

FBOUT to complete the PLL. The integrated PLL synchronizes CLK and FBIN so that there is

nominally zero phase error between CLK and FBIN.

G

11

I

Output bank enable. G is the output enable for outputs 1Y(0:9). When G is low, outputs 1Y(0:9) are

disabled to a logic-low state. When G is high, all outputs 1Y(0:9) are enabled and switch at the same

frequency as CLK.

FBOUT

12

O

Feedback output. FBOUT is dedicated for external feedback. It switches at the same frequency as

CLK. When externally wired to FBIN, FBOUT completes the feedback loop of the PLL. FBOUT has

an integrated 25-

Ω series-damping resistor.

1Y (0:9)

3, 4, 5, 8, 9

15, 16, 17, 20,

21

O

Clock outputs. These outputs provide low-skew copies of CLK. Output bank 1Y(0:9) is enabled via

the G input. These outputs can be disabled to a logic-low state by deasserting the G control input.

Each output has an integrated 25-

Ω series-damping resistor.

AVCC

23

Power

Analog power supply. AVCC provides the power reference for the analog circuitry. In addition, AVCC

can be used to bypass the PLL for test purposes. When AVCC is strapped to ground, PLL is bypassed

and CLK is buffered directly to the device outputs.

AGND

1

Ground

Analog ground. AGND provides the ground reference for the analog circuitry.

VCC

2, 10, 14, 22

Power

Power supply

GND

6, 7, 18, 19

Ground

Ground