LTC4101EG datasheet(21/28 Pages) LINER

21 / 28 page

LTC4101

4101f

OPERATIO

Figure 8. Charging Current Waveform in Low Current Mode

ILIMIT/8

AVERAGE CHARGER CURRENT

4101 F08

~40ms

Figure 9. Adapter Current Limiting

100mV

–

4.99k

CLP

CLN

INFET

4101 F09

LTC4101

0.1

µF

RCL*

VIN

CL1

*RCL =

100mV

ADAPTER CURRENT LIMIT

TO LOAD

the input FET is turned off slowly. If the voltage between

DCIN and CLP is ever less than –25mV, then the input FET

is turned off quickly to prevent significant reverse current

from flowing in the input FET. In this condition the CHGEN

pin is driven low and the charger is disabled.

The AC Present Block (AC_PRESENT)

The DCDIV pin is used to determine AC presence. If the

DCDIV voltage is above the DCDIV comparator threshold

(VACP), then the ACP output pin will be switched to VDD and

the AC_PRESENT bit in the ChargerStatus() function will

be set. If the DCDIV voltage is below the DCDIV compara-

tor threshold minus the DCDIV comparator hysteresis,

then the ACP output pin is switched to GND and the

AC_PRESENT bit in the ChargerStatus() function is cleared.

The ACP output pin is designed to drive 2mA continuously.

Adapter Limiting

An important feature of the LTC4101 is the ability to

automatically adjust charging current to a level which

avoids overloading the wall adapter. This allows the prod-

uct to operate at the same time that batteries are being

charged without complex load management algorithms.

Additionally, batteries will automatically be charged at the

maximum possible rate of which the adapter is capable.

This feature is created by sensing total adapter output

current and adjusting charging current downward if a

preset adapter current limit is exceeded. True analog

control is used, with closed loop feedback ensuring that

adapter load current remains within limits. Amplifier CL1

in Figure 9 senses the voltage across RCL, connected

between the CLP and CLN pins. When this voltage exceeds

100mV, the amplifier will override programmed charging

current to limit adapter current to 100mV/RCL. A lowpass

filter formed by 4.99k and 0.1

µF is required to eliminate

switching noise. If the current limit is not used, CLP should

be connected to CLP, but leave CLN connected to power.

Setting Input Current Limit

To set the input current limit, you need to know the

minimum wall adapter current rating. Subtract 7% for the

input current limit tolerance and use that current to deter-

mine the resistor value.

RCL = 100mV/ILIM

ILIM = Adapter Min Current –

(Adapter Min Current • 7%)

As is often the case, the wall adapter will usually have at

least a +10% current limit margin and many times one can

simply set the adapter current limit value to the actual

adapter rating (see Figure 9).

LTC4101EG датащи(PDF) 21 Page - Linear Technology

LTC4101EG датащи(HTML) 21 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

датащи скачать

ссылки URL