LTC6404 datasheet(17/28 Pages) LINER

17 / 28 page

LTC6404

6404f

PIN FUNCTIONS

potential. On the LTC6404-2, the VOCM pin has a input

resistance of approximately 14k. On the LTC6404-4, the

VOCM pin has a input resistance of approximately 7k. The

VOCM pin should be bypassed with a high quality ceramic

bypass capacitor of at least 0.01μF, (unless you are using

split supplies, then connect directly to a low impedance,

low noise ground plane) to minimize common mode noise

from being converted to differential noise by impedance

mismatches both externally and internally to the IC.

NC (Pins 5, 16): No Connection. These pins are not con-

nected internally.

OUT+, OUT– (Pins 7, 14):

Unﬁltered Output Pins. Besides

driving the feedback network, each pin can drive an ad-

ditional 50

Ω to ground with typical short-circuit current

limiting of ±65mA. Each ampliﬁer output is designed to

drive a load capacitance of 10pF. This basically means

the ampliﬁer can drive 10pF from each output to ground

or 5pF differentially. Larger capacitive loads should be

decoupled with at least 25

Ω resistors in series with each

output. For long-term device reliability, it is recommended

that the continuous (DC + ACRMS) output current be limited

to under 50mA.

OUTF+, OUTF– (Pins 8, 13):

Filtered Output Pins. These

pins have a series 50

Ω resistor connected between the

ﬁltered and unﬁltered outputs and three 12pF capacitors.

Both OUTF+ and OUTF– have 12pF to V–, plus an additional

12pF differentially between OUTF+ and OUTF–. This ﬁlter

creates a differential lowpass frequency response with

a –3dB bandwidth of 88.5MHz. For long-term device

reliability, it is recommended that the continuous (DC +

ACRMS) output current be limited to under 40mA.

IN+, IN– (Pins 15, 6):

Noninverting and Inverting Input Pins

of the Ampliﬁer, Respectively. For best performance, it is

highly recommended that stray capacitance be kept to an

absolute minimum by keeping printed circuit connections

as short as possible, and if necessary, stripping back nearby

surrounding ground plane away from these pins.

Exposed Pad (Pin 17): Tie the pad to V– (Pins 3, 9, and 12).

If split supplies are used, do not tie the pad to ground.

BLOCK DIAGRAM

–

IN–

OUT+

OUTF+

IN+

OUT–

OUTF–

V+

V–

V+

V–

V+

50Ω

12pF

66k

V–

VOCM

V–

6404 BD

V+

V–

50Ω

2 • RVOCM

V–

V+

V–

V+

V–

V+

V–

V+

V–

V+

V–

SHDN

LTC6404-1

LTC6404-2

LTC6404-4

2 • RVOCM

47k

28k

14k

LTC6404 датащи(PDF) 17 Page - Linear Technology

LTC6404 датащи(HTML) 17 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

датащи скачать

ссылки URL