Key Features

12mm Rotary incremental encoder with

LED for use in electronic equipment.

Can be supplied with or without switch

with customisation to standard options.

Characteristics -

Electrical

Pulses:

24

Contact Rating:

0.5mA 5VDC

Dielectric Strength:

300VAC / 1mA, 1 minute

Insulation Resistance (min):

100M ohms at 250VAC

Operating Speed (RPM):

60 RPM

Switch Power Rating (where fitted):

16VDC 3A

Switch Contact Resistance:

100m ohm Max

Electrical Travel:

Continuous

Rotational Noise:

t2 = 2.0 ms max (see below)

Chattering:

t1 & t3 = 3.0 ms max (see below)

Code Off area V = 3.5V or more. Code on area V=1.5V or less

LED

Switch – Dual colour – see below for characteristics

No Switch Single colour– see below for characteristics

Colour options

No Switch – Red, Green, Blue

Switch – 1: Blue/Green, 2: Blue/Orange, 3: Green/Red

Characteristics -

Mechanical

Total Mechanical Travel:

Continuous

Detents:

0, 24

Switch Operating Force:

400+/- 200gf

Switch Travel:

0.5mm

Shaft Type:

F – Flatted, K - Knurled

Shaft Length (from Mounting Surface):

See Chart below

Characteristics -

Environmental

Operating Temperature

-40 - +85 degrees C

Rotational Life

30,000 Cycles

Output Signal Format

Shaft Rotational

Signal

Format

Direction

A (Terminal A-C)

B (Terminal B-C)

A (Terminal A-C)

B (Terminal B-C)

Clockwise

Anticlockwise

Type DPL12 Series

Literature No. 1-1773449-0

Issued: 02-08

Dimensions are shown for

reference purposes only.

Dimensions are in

millimetres unless

otherwise specified.

Specifications subject to

change.

tycoelectronics.com

passives.tycoelectronics.com

12mm Rotary Encoder with LED

Type DPL12 Series