R8C2K datasheet(183/471 Pages) RENESAS

183 / 471 page

R8C/2K Group, R8C/2L Group

16. Timers

Rev.1.10

Dec 21, 2007

Page 166 of 450

REJ09B0406-0110

16.2.3.1

One-Shot Trigger Selection

In programmable one-shot generation mode and programmable wait one-shot generation mode, operation starts

when a one-shot trigger is generated while the TCSTF bit in the TRBCR register is set to 1 (count starts).

A one-shot trigger can be generated by either of the following causes:

• 1 is written to the TOSST bit in the TRBOCR register by a program.

• Trigger input from the INT0 pin.

When a one-shot trigger occurs, the TOSSTF bit in the TRBOCR register is set to 1 (one-shot operation in

progress) after one or two cycles of the count source have elapsed. Then, in programmable one-shot generation

mode, count operation begins and one-shot waveform output starts. (In programmable wait one-shot generation

mode, count operation starts for the wait period.) If a one-shot trigger occurs while the TOSSTF bit is set to 1,

no retriggering occurs.

To use trigger input from the INT0 pin, input the trigger after making the following settings:

• Set the PD4_5 bit in the PD4 register to 0 (input port).

• Select the INT0 digital filter with bits INT0F1 and INT0F0 in the INTF register.

• Select both edges or one edge with the INT0PL bit in INTEN register. If one edge is selected, further select

falling or rising edge with the INOSEG bit in TRBIOC register.

• Set the INT0EN bit in the INTEN register to 0 (enabled).

• After completing the above, set the INOSTG bit in the TRBIOC register to 1 (INT pin one-shot trigger

enabled).

Note the following points with regard to generating interrupt requests by trigger input from the INT0 pin.

• Processing to handle the interrupts is required. Refer to 12. Interrupts, for details.

• If one edge is selected, use the POL bit in the INT0IC register to select falling or rising edge. (The

INOSEG bit in the TRBIOC register does not affect INT0 interrupts).

• If a one-shot trigger occurs while the TOSSTF bit is set to 1, timer RB operation is not affected, but the

value of the IR bit in the INT0IC register changes.

R8C2K датащи(PDF) 183 Page - Renesas Technology Corp