R8C2K datasheet(139/471 Pages) RENESAS

139 / 471 page

R8C/2K Group, R8C/2L Group

12. Interrupts

Rev.1.10

Dec 21, 2007

Page 122 of 450

REJ09B0406-0110

12.6.5

Changing Interrupt Control Register Contents

(a) The contents of an interrupt control register can only be changed while no interrupt requests corresponding

to that register are generated. If interrupt requests may be generated, disable interrupts before changing the

interrupt control register contents.

(b) When changing the contents of an interrupt control register after disabling interrupts, be careful to choose

appropriate instructions.

Changing any bit other than IR bit

If an interrupt request corresponding to a register is generated while executing the instruction, the IR bit

may not be set to 1 (interrupt requested), and the interrupt request may be ignored. If this causes a problem,

use the following instructions to change the register: AND, OR, BCLR, BSET

Changing IR bit

If the IR bit is set to 0 (interrupt not requested), it may not be set to 0 depending on the instruction used.

Therefore, use the MOV instruction to set the IR bit to 0.

(b) regarding changing the contents of interrupt control registers by the sample programs.

Sample programs 1 to 3 are for preventing the I flag from being set to 1 (interrupts enabled) before the interrupt

control register is changed for reasons of the internal bus or the instruction queue buffer.

Example 1:

Use NOP instructions to prevent I flag from being set to 1 before interrupt control register

is changed

INT_SWITCH1:

FCLR

; Disable interrupts

AND.B

#00H,0056H

; Set TRAIC register to 00h

NOP

;

NOP

FSET

; Enable interrupts

Example 2:

Use dummy read to delay FSET instruction

INT_SWITCH2:

FCLR

; Disable interrupts

AND.B

#00H,0056H

; Set TRAIC register to 00h

MOV.W MEM,R0

; Dummy read

FSET

; Enable interrupts

Example 3:

Use POPC instruction to change I flag

INT_SWITCH3:

PUSHC

FLG

FCLR

; Disable interrupts

AND.B

#00H,0056H

; Set TRAIC register to 00h

POPC

FLG

; Enable interrupts

R8C2K датащи(PDF) 139 Page - Renesas Technology Corp

R8C2K датащи(HTML) 139 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL