MMA2201DR2 datasheet(5/10 Pages) FREESCALE

5 / 10 page

MMA2201D

Sensors

Freescale Semiconductor

BASIC CONNECTIONS

Pinout Description

Figure 5. SOIC Accelerometer with Recommended

Connection Diagram

PCB Layout

Figure 6. Recommended PCB Layout for Interfacing

Accelerometer to Microcontroller

NOTES:

1. Use a 0.1

µF capacitor on VDD to decouple the power

source.

2. Physical coupling distance of the accelerometer to the

microcontroller should be minimal.

3. Place a ground plane beneath the accelerometer to

reduce noise, the ground plane should be attached to

all of the open ended terminals shown in Figure 6.

4. Use an RC filter of 1 k

Ω and 0.01 µF on the output of

the accelerometer to minimize clock noise (from the

switched capacitor filter circuit).

5. PCB layout of power and ground should not couple

power supply noise.

6. Accelerometer and microcontroller should not be a

high current path.

7. A/D sampling rate and any external power supply

switching frequency should be selected such that they

do not interfere with the internal accelerometer

sampling frequency. This will prevent aliasing errors.

Table 3. Pin Descriptions

Pin No.

Pin Name

Description

1 thru 3

—

Leave unconnected.

Logic input pin used to initiate self-test.

VOUT

Output voltage of the accelerometer.

STATUS

Logic output pin to indicate fault.

VSS

The power supply ground.

VDD

The power supply input.

9 thru 13

Trim pins

Used for factory trim. Leave

unconnected.

14 thru 16

—

No internal connection. Leave

unconnected.

N/C

VOUT

STATUS

VSS

VDD

N/C

MMA2201D

VOUT

Output

Signal

1 k

Ω

0.01

µF

Logic

Input

VDD

0.1

µF

STATUS

8 VDD

VSS

A/D In

VRH

VSS

VDD

VOUT

VSS

VDD

0.01

µF

1 k

Ω

0.1

µF

0.1

µF

Power Supply

0.1

µF

STATUS

MMA2201DR2 датащи(PDF) 5 Page - Freescale Semiconductor, Inc

MMA2201DR2 датащи(HTML) 5 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10

датащи скачать

ссылки URL