-6-

Nichia

STSE-CC7174A

<Cat.No.070718>

(6) Static Electricity

· Static electricity or surge voltage damages the LEDs.

It is recommended that a wrist band or an anti-electrostatic glove be used when handling the LEDs.

· All devices, equipment and machinery must be properly grounded.

It is recommended that precautions

be taken against surge voltage to the equipment that mounts the LEDs.

· When inspecting the final products in which LEDs were assembled, it is recommended to check

whether the assembled LEDs are damaged by static electricity or not.

It is easy to find

static-damaged LEDs by a light-on test or a VF test at a lower current (below 1mA is recommended).

· Damaged LEDs will show some unusual characteristics such as the leak current remarkably

increases, the forward voltage becomes lower, or the LEDs do not light at the low current.

at

(7) Others

· NSSL100D complies with RoHS Directive.

· Care must be taken to ensure that the reverse voltage will not exceed the absolute maximum rating

when using the LEDs with matrix drive.

· The LED light output is strong enough to injure human eyes.

Precautions must be taken to prevent

looking directly at the LEDs with unaided eyes for more than a few seconds.

· Flashing lights have been known to cause discomfort in people; you can prevent this by taking

precautions during use.

Also, people should be cautious when using equipment that has had LEDs

incorporated into it.

· The LEDs described in this brochure are intended to be used for ordinary electronic equipment (such

as office equipment, communications equipment, measurement instruments and household appliances).

Consult Nichia’s sales staff in advance for information on the applications in which exceptional quality

and reliability are required, particularly when the failure or malfunction of the LEDs may directly

jeopardize life or health (such as for airplanes, aerospace, submersible repeaters, nuclear reactor

control systems, automobiles, traffic control equipment, life support systems and safety devices).

· User shall not reverse engineer by disassembling or analysis of the LEDs without having prior written

consent from Nichia.

When defective LEDs are found, the User shall inform Nichia directly before

disassembling or analysis.

· The formal specifications must be exchanged and signed by both parties before large volume purchase begins.

· The appearance and specifications of the product may be modified for improvement without notice.