RT9178 datasheet(4/11 Pages) RICHTEK

номер детали	RT9178

подробное описание детали	200mA, Ultra-Low Noise, Ultra-Fast CMOS LDO Regulator

PDF	11 Pages

Scroll/Zoom	100%

производитель	RICHTEK [Richtek Technology Corporation]

домашняя страница	http://www.richtek.com

Logo

4 / 11 page

RT9178

DS9178-16 April 2008

www.richtek.com

Note 1.

Stresses listed as the above "Absolute Maximum Ratings" may cause permanent damage to the device. These are for

stress ratings. Functional operation of the device at these or any other conditions beyond those indicated in the

operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended

periods may remain possibility to affect device reliability.

Note 2.

Devices are ESD sensitive. Handling precaution is recommended.

Note 3.

The device is not guaranteed to function outside its operating conditions.

Note 4.

The dropout voltage is defined as VIN -VOUT, which is measured when VOUT is VOUT(NORMAL)

− 100mV.

Note 5.

Regulation is measured at constant junction temperature by using a 20ms current pulse. Devices are tested for load

regulation in the load range from 1mA to 200mA.

Note 6.

Quiescent, or ground current, is the difference between input and output currents. It is defined by IQ = IIN - IOUT under

no load condition (IOUT = 0mA). The total current drawn from the supply is the sum of the load current plus the ground

pin current.

Note 7.

Standby current is the input current drawn by a regulator when the output voltage is disabled by a shutdown signal

(VEN = GND). It is measured with VIN = 6V.

Note 8.

θJA is measured in the natural convection at TA = 25°C on a low effective thermal conductivity test board of

JEDEC 51-3 thermal measurement standard.

RT9178 датащи(PDF) 4 Page - Richtek Technology Corporation