| поискавой системы для электроныых деталей |
|
ST72141K2 датащи(PDF) 50 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
ST72141K2 датащи(HTML) 50 Page - STMicroelectronics |
|
50 / 132 page ![]() ST72141K 50/132 MOTOR CONTROLLER (Cont’d) Sensor Mode In sensor mode, the rotor position information is given to the peripheral by means of logical data on the three inputs MCIA, MCIB and MCIC. For each step one of these three inputs is selected (IS[1:0] bits in register MPHST) in order to detect the Z event. In this case Demagnetization has no meaning and the relevant features such as the special PWM configuration, DS or DH management, 20-µs filter; are not available (see Table 14). For this configuration the rotor detection doesn’t need a particular phase configuration to validate the measurement and a Z event can be read from any detection window. A fixed sampling frequency (800 kHz) is used, that means the Z event and po- sition sensoring is more precise than it is in sen- sorless mode. The minimum off time for current control PWM is also reduced to 1.25 µs. Procedure for reading sensor inputs in Direct Access mode: In Direct Access mode, the periph- eral clock is disabled as shown in Table 25. As the data present on the selected input is synchronized by a 800 kHz clock, the sensor can’t be read di- rectly (the value is latched). To read the sensor data the following steps have to be performed: 1. Select the appropriate MCIx input pin by means of the IS[1:0] bits in the MPHST register 2. Switch from direct access mode to indirect access mode in order to latch the sensor data (DAC bit in MCRA register). 3. Switch back to direct access mode. 4. Read the comparator output (HST bit in the MIMR register) Table 14. Sensor mode selection SR bit Mode OS2 bit use Event detection sampling clock Filtering Behaviour of the output PWM 0 Sensors not used Enabled D: Clock 1.25 µs Z: SA&OT config. 20 µs after C for D event 20 µs after D for Z event “Before D” behaviour & “after D” behaviour 1 Sensors used Disabled Z: Clock 1.25 µs20µs after C for Z event Only “after D” behaviour |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |