Assembly instructions

1. Unpack the case from the box and remove the accessories envelope.

2. Remove the heatsink from the envelope inside the case.

3. Remove the heatsink backing and stick the heatsink to the raised section of the CPU

on Raspberry Pi 5. Push down on the heatsink to achieve good adhesion of the heatsink

to the CPU.

4. Remove the four silicone feet from the accessories envelope and stick these to the

underside of the base of the case in the lozenge-shaped areas provided.

5. Unclip the white frame containing the fan assembly from the red base, and insert your

Raspberry Pi 5 into the base. The board fits under the plastic tab at the SD card end.

Make sure that the board sits flat in the base and that the connectors are aligned to the

holes.

6. Lay the white frame containing the fan assembly upside-down next to the red base,

and connect the fan cable to the four-pin connector labelled ‘FAN’ on Raspberry Pi 5.

Take care to ensure that the cable’s connector is the correct way round when inserting it.

Make sure that the fan cable is fully connected.

7. Clip the the white frame containing the fan assembly back onto the red base to complete

the assembly.

8. Now you can connect the necessary cables to your Raspberry Pi and turn on power.

The button on the case can be used to power up or power down your Raspberry Pi.

9. Optionally, the lid can be unclipped to reveal the fan, mounting points, and cable breakout

slots, such as GPIO.

10. Holes for optional HAT and case mounting and for case stacking are provided

in the transparent part of the fan assembly and in the underside of the base.

Suitable stand-offs and GPIO header extenders (not included) are required to mount

HATs on top of the case.

11. The fan assembly with its transparent surround can be unclipped from the white frame

if you wish to use the case without the fan.

Raspberry Pi Case for Raspberry Pi 5 – Raspberry Pi Ltd

4