F3S-TGR-N

@C

13

Safety Precautions

Application Precautions

• Do not use the product in locations subject to explosive or

flammable gases.

• Do not use load currents exceeding the rated value.

• Be sure to wire each conductor correctly.

• Be sure to confirm correct operation after completing mounting and

adjustment.

• Do not drop or attempt to disassemble the product.

• Be sure to use the correct combination of switch and actuator.

• Use a power supply of the specified voltage. Do not use power

supplies with large ripples or power supplies that intermittently

generate incorrect voltages.

• Capacitors are consumable and require regular maintenance and

inspection.

Installation Locations

Do not install the product in the following locations. Doing so may

result in product failure or malfunction.

• Locations subject to direct sunlight

• Locations subject to humidity levels outside the range 35% to 85%

or subject to condensation due to extreme temperature changes

• Locations subject to corrosive or flammable gases

• Locations subject to shocks or vibration in excess of the product

ratings

• Locations subject to dust (including iron dust) or salts

Take appropiate and sufficient countermeasures when using the

product in the following locations.

• Locations subject to static electricity or other forms of noise

• Locations subject to possible exposure to radioactivity

• Locations subject to power supply lines

• It is advisable to mount the switches on non ferrous materials.

The presence of ferrous material can effect switching sensitivity.

Solvents

Ensure that solvents, such as alcohol, thinner, trichloroethane, or

gasoline do not adhere to the product. Solvents may cause markings

to fade and components to deteriorate.

Guard Stops

Mounting Direction

Using for Hinged Doors

On hinged doors, install the Sensor at an opening edge as shown

below.

Mutual Interference

If the switch and actuator are mounted in parallel, be sure to separate

them by at least 25 mm, as shown below.

Be sure to turn OFF the power before performing wiring.

Do not touch charge parts (e.g., terminals) while power is

ON. Doing so may result in electric shock.

Do not allow the actuator to come close to the switch with

the door open. Doing so may cause machinery to start

operating and may result in injury.

Keep actuators (magnets) away from magnetically sensi-

tive equipment like PC harddisks, floppy disks etc. The

magnetic field of the magnet will damage existing data.

!WARNING

Use guard stops in the way shown below to ensure that

the switch and actuator do not make contact when the

guard door is closed.

!CAUTION

min. 2 mm

min. 5 mm

(Standard Sensor)

max. 4 mm (Elongated Sensor)

Guard door

Guard Stops

Switch

Actuator

CORRECT

INCORRECT

CORRECT

CORRECT

CORRECT

INCORRECT

25 mm min.

Switch

Switch

Actuator

Guard door

Actuator