www.element14.com

www.farnell.com

www.newark.com

www.cpc.co.uk

Page <2>

V1.0

24/05/13

CTFC Series

Heat Shrink Tubing

Important Notice : This data sheet and its contents (the “Information”) belong to the members of the Premier Farnell group of companies (the “Group”) or are licensed to it. No licence is granted

for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change

without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any

error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any

assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the

Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group’s liability for death or personal injury resulting from its negligence.

pro-POWER is the registered trademark of the Group. © Premier Farnell plc 2012.

Part Number Table

Description

Part Number

Heatshrink, Adhesive, 3mm, Black, 1.2m

CTFC-3/1-0-STK

Heatshrink, Adhesive, 6mm, Black, 1.2m

CTFC-6/2-0-STK

Heatshrink, Adhesive, 9mm, Black, 1.2m

CTFC-9/3-0-STK

Heatshrink, Adhesive, 12mm Black, 1.2m

CTFC-12/4-0-STK

Heatshrink, Adhesive, 18mm, Black, 1.2m

CTFC-18/6-0-STK

Heatshrink, Adhesive, 24mm, Black, 1.2m

CTFC-24/8-0-STK

Heatshrink, Adhesive, 39mm, Black, 1.2m

CTFC-39/13-0-STK

Test

Test Method

Test Requirement

Min. Tensile Strength

ISO 37

9MPa

Min. Ultimate Elongation

ISO 37

200%

Heat Shock

4 Hours at 150°C

Pass - no Dripping, Cracking or Flowing of Outer Wall

Heat Ageing

168 Hours at 125°C

Low Temperature Flexibility

4 Hours at -55°C

Pass - no Cracking

Min. Dielectric Strength

IEC 243

12MV/m

Fluid Resistance

24 Hours at 23°C, ISO 37 Min. Tensile Strength : 5MPa

Min. Ultimate Elongation : 200%

Test Fluids

Petrol 100 Octane

Engine Oil (SAE 20W/50)

Hydraulic Fluid (SAE J1703)

Performance

Part Number Explanation:

CTFC

3/1

0

Series

Inside Diameter

Colour Code

Inside Diameter : Expanded as supplied/Recovered after heating.

Colour Code

: 0 = Black.