M51995AP/AFP

REJ03D0835-0201 Rev.2.01 Nov 14, 2007

Page 30 of 40

4. Power supply circuit for easy start-up

When IC starts to operate, the voltage of the CVCC begins to decrease till the CVCC becomes to be charged from the

third winding of main-transformer as the ICC of the IC increases abruptly. In case shown in figure 22 and 23, some

“unstable start-up” or “fall to start-up” may happen, as the charging interval of CVCC is very short duration; that is

the charging does occur only the duration while the induced winding voltage is higher than the CVCC voltage, if the

induced winding voltage is nearly equal to the “operation-stop voltage” of type M51995.

It is recommended to use the 10 to 47

µF for C

VCC1, and about 5 times capacity bigger than CVCC1 for CVCC2 in figure

25.

+

+

VCC

GND

CVCC1

CVCC2

R1

Main

transformer

third winding

M51995A

Figure 25 DC Source Circuit for Stable Start-up

OVP Circuit

(1) To avoid the miss operation of OVP

It is recommended to connect the capacitor between OVP terminal and GND for avoiding the miss operation by the

spike noise.

The OVP terminal is connected with the sink current source (

≈150 µA) in IC when OVP does not operate, for

absorbing the leak current of the photo coupler in the application.

So the resistance between the OVP terminal and GND for leak-cut is not necessary.

If the resistance is connected, the supply current at the OVP reset supply voltage becomes large.

As the result, the OVP reset supply voltage may become higher than the operation stop voltage.

In that case, the OVP action is reset when the OVP is triggered at the supply voltage a little high than the operation

stop voltage.

So it should be avoided absolutely to connect the resistance between the OVP terminal and GND.

+

VCC

OVP

GND

Photo coupler

10 k

M51995A

Figure 26 Peripheral Circuit of OVP Terminal