MK50H28 datasheet(49/64 Pages) STMICROELECTRONICS

49 / 64 page

4.4.10 Disabling the MK50H28

The following procedure should be followed to disable the MK50H28:

1. Issue the STOP primitive through CSR1. This will disable the MK50H28 from receiving or trans-

mitting. The TD pin will be held high while the MK50H28 is in the Stopped mode. The STOP bit

in CSR0 will be set and interrupts will be disabled. If reception or transmission of a frame is in

progress, then received data may be lost, and the transmitted frame will be aborted.

4.4.11 Re-enabling the MK50H28

The same procedure should be followed for re-enabling the MK50H28 as was used to Initialize upon

power up. If the Initialization Block and the hardware configuration have not changed, then steps 1,2,3,

4 and 5 of the Initialization sequence may be omitted.

4.4.12 MK50H28 Internal Self Test

The MK50H28 contains an easy to use internal self test designed to test, with a high fault coverage, all

of the major blocks of the device except the DMA controller. It is suggested that a loopback test also be

performed to more completely test the DMA controller.

The following procedure should be followed to execute the internal self test:

1. Reset the device using the RESET pin.

2. Set bit 04 of CSR4.

3. Issue a Self Test Request through CSR1.

4. Poll CSR1, waiting for the PAV bit in CSR1 to be set by the MK50H28.

5. After the PAV bit is set, read CSR1. The success or failure of the test is indicated in the PPARM

and PPRIM fields as follows:

PPARM

PPRIM

RESULT

Passed self test.

Failed the reset test of the self test.

Failed the self test in the micro controller RAM.

Failed the self test in the ALU.

Failed the self test in the timers.

Failed the self test in the transmitter and/or receiver.

Failed the self test in the CSR’s and/or bus master.

Otherwise

Failed device.

6. If the PAV bit is not set within 75 msec (SYSCLK = 10MHZ), then the MK50H28 is unable to re-

spond to the Self Test Request and will not complete successfully. If the self test passes, then it

may be immediately re-executed from step 3, otherwise re-execution should proceed from step 1.

MK50H28

49/64

MK50H28 датащи(PDF) 49 Page - STMicroelectronics