Time Electronics

Time Electronics Ltd, Unit 5, TON Business Park, 2-8 Morley Road, Tonbridge, Kent, TN9 1RA, United Kingdom

T: +44 (0) 1732 355993 | F: +44 (0) 1732 350198 | mail@timeelectronics.co.uk | www.timeelectronics.com

8030 Controller

|

7161 manifold with UUT

| 7115 Trap

Description

The 7115 is a contamination trap designed for use with pressure equipment,

such as controllers, calibrators and pressure generators. It protects against

impurities, liquids (water, oil etc.) and residues released by manifolds,

gauges, transmitters and other pressure instrumentation under test.

The 7115 is primarily intended for use with the 8030 benchtop pressure

controller and equivalent 8030B CalBench module. It is supplied as standard

with both units. The trap provides a level of protection for the controller's

internal system components that require mechanical operation to be smooth

and unobstructed.

During pressure testing applications, a controller or calibrator will transition

from a higher set point to a lower one. At this time, liquid and residues

present in the pneumatic system may flow into the controller/calibrator.

This may also occur when selecting negative set points (vacuum). The 7115

is required to filter out contaminants.

Set up is simple and fast, with the trap connected between the controller/

calibrator and the unit under test. The top of the trap indicates the clean

side (controller) and the UUT side. The unit is pressure rated from vacuum

to 210 bar operation with two high pressure minimess type fittings for

connections. Hoses are supplied as standard. It is also suitable for use

with calibration manifolds such as the 7161P quad port pneumatic model.

On the CalBench the 7115 can be used with the 8030B controller module

or the RMTEG regulated pressure calibrator modules.

Ordering Information

7115........Contamination Trap for Pressure Controllers and Calibrators

Features/Specifications

• Contamination trap to protect pressure calibrators and controllers

• Supplied as standard with 8030 and 8030B pressure controllers

• Pressure range: -1 to 210 bar

• Pressure media: Pneumatic only, gas or air

• Material: Stainless steel, polycarbonate and nitrile rubber seals

• Connections: 2 x adaptors – minimess type with hoses supplied

• Dimensions: W 120 x D 120 x H 120 mm

• Weight: 1 kg

• Operating Temperature: 10 to 40 °C (50 to 104 °F)

Storage Temperature: 0 to 70 °C (32 to 158 °F)

Air Humidity: 0 to 95% (RH without moisture condensation)

Due to continuous development Time Electronics reserves the right to change specifications without prior notice.

v2a

04/20

7115 Contamination Trap