Time Electronics, Botany Industrial Est. Tonbridge, Kent. England. TN9 1RH.

Tel: +44 (0)1732 355993 Fax: +44 (0)1732 770312 E-mail: mail@timeelectronics.co.uk

www.timeelectronics.com

1044 Voltage and Current Calibrator

Time Electronics

Calibration, Test & Measurement

V1b 27/03/09



Source and Measure

Current and Voltage



3 Voltage Ranges: 0 – 20V



3 Current Ranges: 0 – 20mA



0.05% Accuracy



Portable with carry case

The 1044 is an accurate, low cost portable calibrator designed for use in a wide range of

applications. High performance and ease of use make it suitable for test engineers, R&D,

service, and calibration technicians.

Offering both versatility and practicality the 1044 can source and measure voltage and

current. The 0.05% accuracy is ideal for simulation and calibration in most engineering

applications.

The 1044 combines the advantages of digital accuracy with analog controls. Progressing

from the familiar functions of the Time Electronics 1030 calibrator, the 1044 offers more

ranges, better accuracy and the ability to measure as well as source.

The large, easy to read LCD display shows the actual output, even when the connected load

exceeds the specifications. This important feature eliminates the risk of large errors when

connecting to unknown loads. The display also shows if the battery becomes low.

In the source mode, voltage up to 20V and current up to 20mA may be generated in three

ranges. When in current source mode the 1044 has a high 24V compliance voltage which is

ideal for powering process control loops.

In the measurement mode, the range and function can be easily selected with the measured

input accurately shown on the LCD display, operating in a similar way to a multimeter.

The 1044 is housed in a pocket sized, ABS case and comes with a leatherette carry case

containing a compartment for storing test leads. Connections are by standard 4mm plugs or

by simply clamping the wires under the terminals.

A single 9V battery powers the unit or an external 12V DC power supply may be used which

disconnects the internal battery.