8W-N

■Panel Cut-Out Dimensions

Series

8N

8R

8P

8Y

Panel thickness

1.5 mm Max. 2.5 mm Max.

2 mm Max.

3 mm Max.

4.5 mm Max.

5 mm Max.

6 mm Max.

Dimensions

With Locking Ring Without Locking Ring With Locking Ring Without Locking Ring

With Locking Ring Without Locking Ring

■PC Hole Layouts

Series

8N・8P

8R・8W

Dimensions

1 pole

2 poles

1 pole

2 poles

3 poles

4 poles

■Precautions（8N・8P・8R・8W・8Y）

1. Soldering Specifications

⑴Manual soldering

Device：Solder iron

①420℃ Max. 3 sec. Max.

⑵Auto soldering

②The above-stated soldering conditions shall apply

only to switches with straight terminals. Auto

soldering is not possible with right-angle terminals.

Switches with right-angle terminals should be

soldered manually according to the conditions

specified in (1) above.

⑶When putting the switches through an aging process

after they were soldered onto the printing board or after

installed into a complete end product, be sure to remove

the buttons ofthe switches.,

2. Mounting

●Do not bend the terminals before mounting the

switch on the PC board.

●After mounting the switch, do not place the device

in such a way that the device weight will be applied

on to the actuator of the switch.

●For switches with straight terminals, solder the

switch on the PC board after fixing the switch on

the panel with a nut.

3. Flux Cleaning

⑴Solvent : Fluorine or Alcohol type.

⑵

8A/B/C/D/E/F/J/S series are not washable. To wash the

PC board, clean the soldering surface of the PC board

with a brush so that the switch is not exposed to the

cleaning solution.

■Packaging Specification

Perforated Plastic Bag

25 pcs/pack