March 08, 2024

WLF12 Flexible LED Strip Light Instruction Manual 

© Banner Engineering Corp. All rights reserved.

 

 

9

Chapter Contents

Dimensions......................................................................................................................................................................................................... 10

 

Supply Voltage

24 V DC (±10%)

Use only with a suitable Class 2 power supply (UL) or SELV

power supply (CE)

Supply Current

Light Length

Typical Current (A) at

25 °C

Maximum Current (A)

at -20 °C

300 mm

0.14

0.165

600 mm

0.28

0.33

1200 mm

0.56

0.66

2000 mm

0.933

1.1

3000 mm

1.4

1.65

4000 mm

1.867

2.2

Supply Protection Circuitry

Protected against reverse polarity and transient voltages

Connections

150 mm (6 in) PVC-jacketed cable with a 4-pin M12 male

quick-disconnect connector

Models with a quick-disconnect connector require a mating

cordset

Do not spray cable with high-pressure sprayer or cable

damage will result.

Operating Temperature

–20 °C to +45 °C (–4 °F to +113 °F)

Storage Temperature

–35 °C to +70 °C (–31 °F to +158 °F)

Environmental Rating

Rated IP66, IP67, IP69K per DIN 40050-9

Suitable for damp locations per UL 2108

Do not spray cable with a high-pressure sprayer or cable

damage will result.

Vibration and Mechanical Shock

Vibration: 10 Hz to 55 Hz, 1.0 mm peak-to-peak amplitude per

IEC 60068-2-6

Shock: 15G 11 ms duration, half sine wave per IEC

60068-2-27

Construction

Clear silicone outer housing and end caps

Internally silicone-encapsulated LEDs

Very high-bonding strength tape and protective liner pre-

applied to the back of the light

Application Notes

When cutting the WLF12, it is important to use the extra end

cap supplied along with silicone glue. See "Cutting

Instructions" on page 6. Cutting the WLF12 voids the Limited

Warranty.

For indoor or outdoor use, if exposure to direct sunlight is 

avoided.

Do not use in applications with repeated flexing.

Minimum Bend Radius

15 mm

Required Overcurrent Protection

WARNING: Electrical connections must

be made by qualified personnel in

accordance with local and national

electrical codes and regulations. 

Overcurrent protection is required to be provided by end

product application per the supplied table. 

Overcurrent protection may be provided with external fusing

or via Current Limiting, Class 2 Power Supply.

Supply wiring leads < 24 AWG shall not be spliced.

For additional product support, go

to www.bannerengineering.com. 

Supply

Wiring

(AWG)

Required Overcurrent

Protection (A)

Supply

Wiring

(AWG)

Required Overcurrent

Protection (A)

20

5.0

26

1.0

22

3.0

28

0.8

24

1.0

30

0.5

Mounting

Use pre-applied, very high-bonding strength tape to mount the

WLF12 without mounting brackets, see "Mounting

Instructions" on page 7

If needed, use mounting bracket LMBWLF12C, see "Mounting

Accessories" on page 11

Certifications

Banner Engineering BV

Park Lane, Culliganlaan 2F bus 3

1831 Diegem, BELGIUM

Turck Banner LTD Blenheim House

Blenheim Court

Wickford, Essex SS11 8YT

GREAT BRITAIN

Specifications

Chapter 6