User Manual

13 of 24

Version 1.0

2017-11

SPOC (TM)+2 User Manual

Multichannel SPI High-Side Power Controller

2.2

User Interface

2.2.1

STD-View

Figure 17 - User Interface - STD-View

Table 4 - STD-View

1 Menu bar

*

2 Port selection

Software should detect the Comport automatically.

 If not: select the needed Comport.

3 Standard or SPI view

Change between a button based control(Figure 17) and a low level SPI command

control(Figure 18)

4 Device selection

Select the used device type

5 Direct inputs and LHI

 Switch IN0-IN2 on or off

 LHI can be set on or off

6 Input logics

OR/AND operation between direct inputs (IN0-IN3) with the channel’s on-status

(channel 0 to 3)

7 Reset

Reset SPOCTM+2

8 Clear

Clear all Error latches and error counter

9 Channels

Indicates the Status of a channel (Error, Warn, OUT, Slew rate)

and configures the channel (ON, Sense ratio, Restart Strategy, OC level)



10 Checksum

Shows the calculated checksum reflecting the configuration. This value will be

transmitted when clicking on send checksum.

11 IS MUX

Configure the mux setting. For more information see datasheet of SPOCTM+2

12 Error counter

Error counter of the selected channel



13 Slew rate settings

configures the slew rate of the selected channel

14 Status display

Visualizes the standard diagnosis (spi response)

15 Exit button

Closes connection and program