8

Copyright © Infineon Technologies AG 2023. All rights reserved.

restricted

2023-06-12

Usecase: Software -> Double code word calibration

› Double code word calibration procedure

› Automatic (Manual checkbox is unchecked; left picture)

› Select sensor that needs calibration

› Fill target sensitivity textbox with desired sensitivity value

› Fill Itest textbox with the value of the current used for calibration

› Follow pop-up instructions

› At the end of the procedure, new gbase and obase values will be provided in the

lower textbox

› Press Burn EEPROM button to burn new values in sensor eeprom

› Select a different sensor and restart calibration

› Manual (Manual checkbox is checked; right picture)

› Select sensor that needs calibration

› Fill target sensitivity textbox with desired sensitivity value

› Fill Itest textbox with the value of the current used for calibration

› Fill VDD textbox with sensor VDD value (measured with multimeter)

› Press Start Procedure button

› Popup will appear and ask for multimeter readout of sensor Aout

› 6 measurements are needed during calibration

› At the end of the procedure, new gbase and obase values will be provided in the

lower textbox.

› Press Burn EEPROM button to burn new values in sensor eeprom