Use Limitation

This respirator does not supply oxygen. Do not use in

atmospheres containing less than 19.5%* oxygen.

1. Do not use for respiratory protection against atmospheric

contaminants that have poor warning properties or are

unknown or immediately dangerous to life and health (IDLH)

or against contaminants which generate high heats of reaction

with chemical filters.

2. Do not misuse, alter, modify or repair this product.

3. Do not use with beards or other facial hair that prevent direct

contact between face and edge of the respirator.

4. Do not use with unknown concentrations of contaminants.

5. Do not use for escape purposes.

6. Leave the work area immediately and check the integrity of

the respirator and replace face mask if:

- Damage has occurred or is apparent.

- Breathing becomes difficult or increased breathing

resistance occurs.

- Dizziness or other distress occurs.

- You taste or smell the contaminant or an irritation occurs.

7. Store this device in a sealed container away from

contaminated areas when not in use.

8. Use strictly in accordance with respirator and filter user

instruction leaflet.

9. In case of intended use in explosive atmospheres, contact 3M

technical service.

* 3M definition minimum 19.5% by volume oxygen

Fitting Instructions

Before assigning any respirator to be worn in a contaminated

area, we recommend that a qualitative or quantitative fit check be

performed before entering the workplace.

Fitting instructions must be followed each time the respirator is

worn.

1. Assemble/adjust head cradle by feeding the perforated strip

through the buckle and pressing down on the stud at the

required length. Repeat for second strip.

2. Place the respirator over the face, fitting it comfortably on

bridge of the nose, then pull the head harness over the crown

of the head.

3. If necessary remove the respirator and readjust the head

cradle to a comfortable fit and repeat step 2.

4. Take a bottom strap in each hand, place them at the back of

the neck and hook the straps together

5. Tighten the top head harness first by pulling on the ends to

achieve a comfortable and secure fit. Tighten bottom straps in

a similar manner. Strap tension may be decreased by pushing

out on back side of buckles.

6. (Where applicable) After tightening the head harness (see 5),

slide the 4 plastic