22

www.lemo.com

®

®

DISCLAIMER The information contained within this catalog and the functions offered are intended to provide information about products. All reasonable efforts have been made to ensure the accuracy of the

information. However, LEMO cannot be held responsible for any errors. LEMO does not warrant the accuracy and reserves the right to make changes to the catalog and its functions at any time without notice.

Terminating of plugs with solder contacts and cable collet

Cable preparation

1. Strip the cable according to the given dimensions.

(The end of the cable jacket must be cut properly).

Cable termination

2. Slide it into the collet nut ➀, the collet ➁, the gland

➂ and the earthing cone ➃.

3. In case of a screened cable, fold screen back

over the extremity of the earthing cone.

Arrange the conductors according to the insulator

➄ marking by avoiding to twist them.

Fit conductor into the contacts ➅ and solder.

Verify that insulator and insulation remain clean.

4. Locate the slotted upper half ➆ of the split insert

carrier over the shoulder and key on the insulator

then align and press together the other half ➇ to

form a complete cylinder.

Push the earthing cone against the insert carriers

whilst checking that the screen is being clamped

around the whole circumference and cut, if nec-

essary, the excess screen.

Push the gland, and collet against the earthing

cone. Push the cable forward and verify that cable

jacket is located under the gland.

5. Next slide the plug shell ➈ over the insulator

assembly making sure that the key on the insert

carrier goes into the keyway (under the color point)

inside the shell.

Locate the key of the collet into the slot of the

shell. Finally screw the collet nut with the appropriate

tool and tighten to the maximum torque value

(see page 20).

Solder

➀

➁

➂ ➃

➅

➇

➈

1

2

3

4

5

➆

➄