User Manual

3-5

V2.0

Application Kit TC3X7 V2.0

2018-06

Application Kit Manual TC3X7

Hardware: Application Kit TC3X7 V2.0

Application Kit Information

NOTE: Before connecting the board to the PC, make sure that the actual DAS software is installed on the PC. For

actual DAS software please contact your local FAE.

The software can also be found on:

DAS website

3.8.1

Serial Connection to PC

After the first connection of USB to a PC the needed driver will be installed automatically. During this there will

be created a new COM port on PC. This COM port can be used to communicate with the board via ASCLIN0 of the

device. Per default the ASCLIN0 is used on P14.0 and P14.1 (e.g. Generic Bootstrap Loader) .

3.8.2

miniWiggler JDS

The miniWiggler JDS is a low cost debug tool which allows you access to the JTAG of the device. Make sure that

you have the latest DAS release. Debugging is possible via the DAS Server ‘UDAS‘. Please contact your prefered

debug vendor for support of DAS.

If you have connected the board to the PC and there runs the DAS server, then a working connection is visible via

the green ACTIV LED.

The status RUN LED is switched on/off through the DAS Server, depending on the used debugger (client).

IMPORTANT: Make sure that there is no or a tristated connection on X301 (OCDS1) and X302 (DAP) if the ACTIV LED

is on.

3.9

Beeper

The board has an electro-acoustic transducer which can be used for an acoustic output. The transducer is

connected to pin P33.0 and needs a 2048Hz frequency.

3.10

MultiCAN

On the board is one CAN transceiver (CAN FD capable) connected to the CAN module 0 node 0 (P20.7 and P20.8)

on TC3X7. Optional the CAN transceiver can be connected to CAN module 0 node 2 (P10.2 and P10.3). To do this

remove resistor R269, R270 and assemble R257, R258 with 0R Resistor. For location of this resistors please see the

Top Layer assembling Figure 7-5.

Note:

If the board is assembled with TC397 and TLF35584QVVS2 (3,3V version) then the SDMMC module is

connected directly to the SD card. In this case P20.7 and P20.8 are used by the SDMMC and the

transceiver is connected to P10.2 and P10.3.

The transceiver is connected to an IDC10 plug. For the pinout of IDC10 plug see Figure 6-4. You can use a IDC

female connector with crimpconnector, flat cable and SUB-D 9 plug with crimpconnector to have a 1:1 adapter

to SUB-D 9.

3.11

LIN

On the board is one LIN transceiver connected to the ASCLIN2 (P10.5 and P10.6) on TC3X7. The transceiver are

connected to one IDC10 plug. For the pinout of IDC10 plug see Figure 6-5. You can use a IDC female connector with

crimpconnector, flat cable and SUB-D 9 plug with crimpconnector to have a 1:1 adapter to SUB-D 9.

3.12

Ethernet

The Application Kit provide a RJ45 connector (X204) for twisted pair ethernet connections.The board use a

Realtek Integrated 10/100/1000M Ethernet Precision Transceiver RTL8211FI-CG as physical interface device. For