PCM1602A datasheet(36/46 Pages) TI2

номер детали	PCM1602A

подробное описание детали	24-Bit, 192-kHz Sampling, 6-Channel, Enhanced Multilevel, Delta-Sigma Digital-to-Analog Converter

PDF	46 Pages

Scroll/Zoom	100%

производитель	TI2 [Texas Instruments]

домашняя страница	https://www.ti.com

Logo

36 / 46 page

B0008-03

−

Z–1

8-Level Quantizer

−

Z–1

8 fS

OUT

64 fS

Z–1

PCM1602A

SLES146A – AUGUST 2005 – REVISED OCTOBER 2010

www.ti.com

THEORY OF OPERATION

The DAC section of the PCM1602A is based on a multi-bit delta-sigma architecture. This architecture uses a

fourth-order noise shaper and an 8-level amplitude quantizer, followed by an analog low-pass filter. A block

diagram of the delta-sigma modulator is shown in Figure 36. This architecture has the advantage of stability and

improved jitter tolerance, when compared to traditional 1-bit (2-level) delta-sigma designs.

Figure 36. Eight-Level Delta-Sigma Modulator

The combined oversampling rate of the digital interpolation filter and the delta-sigma modulator is 32 fS, 64 fS, or

128 fS. The total oversampling rate is determined by the desired sampling frequency. If fS ≤ 96 kHz, then the

OVER bit in register 12 can be set to an oversampling rate of 64 fS or 128 fS. If fS > 96 kHz, then the OVER bit

can be used to set the oversampling rate to 32 fS or 64 fS. Figure 37 shows the out-of-band quantization-noise

plots for both the 64× and 128× oversampling scenarios. Notice that the 128× oversampling plot shows

significantly improved out-of-band noise performance, allowing for a simplified low-pass filter to be used at the

output of the DAC.

Submit Documentation Feedback

Product Folder Link(s): PCM1602A

PCM1602A датащи(PDF) 36 Page - Texas Instruments