Device description and operation

L6741

8/16

5.1

High-impedance (HiZ) management

The Driver is able to manage High-Impedance state by keeping all MOSFETs in off state. If

the PWM signal remains in the HiZ window for a time longer than the hold-off time, the

device detects the HiZ condition so turning off all the MOSFETs. The HiZ window is defined

See Figure 4 for details about HiZ timings.

The implementation of the High-Impedance state allows the controller that will be connected

to the driver to manage High-Impedance state of its output, avoiding to produce negative

undershoot on the regulated voltage during the shut-down stage. Furthermore, different

power management states may be managed such as pre-bias start-up.

5.2

Preliminary OV protection

After VCC has overcome its UVLO threshold and while the PWM signal is in the HiZ window,

L6741 activate the Preliminary-OV protection.

The intent of this protection is to protect the load especially from High-Side MOSFET fail-

ures during the system start-up. In fact, VRM, and most in general PWM controllers, have a

12V bus compatible turn-on threshold and results to be non-operative if VCC is below that

turn-on thresholds (that results being in the range of about 10V). In case of an High-Side

mosfet failure, the controller won’t recognize the over voltage until VCC = ~10V (unless

other special features are implemented): but in that case the output voltage is already at the

same voltage (~10V) and the load (CPU in most cases) already burnt.

L6741 by-pass the PWM controller by latching on the Low-Side MOSFET in case the

HiZ window, the protection is reset and the control of the output voltage is transferred to the

controller connected to the PWM input.

Since the Driver has its own UVLO threshold, a simple way to provide protection to the out-

put in all conditions when the device is OFF consists in supplying the controller through the

the Low-Side mosfet is driven with 5V assuring a reliable protection of the load.

Preliminary OV is active after UVLO and while the Driver is in HiZ state and it is disabled

after the first PWM transition. The controller will have to manage its output voltage from that

time on.

5.3

Internal BOOT diode

L6741 embeds a boot diode to supply the High-Side driver saving the use of an external

component. Simply connecting an external capacitor between BOOT and PHASE complete

the High-Side supply connections.

To prevent bootstrap capacitor to extra-charge as a consequence of large negative spikes,

BOOT pin.