M24C64 datasheet(14/38 Pages) STMICROELECTRONICS

14 / 38 page

Device operation

M24128, M24C64, M24C32

14/38

4.5

Memory addressing

To start communication between the bus master and the slave device, the bus master must

initiate a Start condition. Following this, the bus master sends the device select code, shown

in Table 3 (on Serial Data (SDA), most significant bit first).

The device select code consists of a 4-bit device type identifier, and a 3-bit Chip Enable

“Address” (E2, E1, E0). To address the memory array, the 4-bit device type identifier is

1010b.

Up to eight memory devices can be connected on a single I2C bus. Each one is given a

unique 3-bit code on the Chip Enable (E0, E1, E2) inputs. When the device select code is

received, the device only responds if the Chip Enable Address is the same as the value on

the Chip Enable (E0, E1, E2) inputs.

The 8th bit is the Read/Write bit (RW). This bit is set to 1 for Read and 0 for Write operations.

If a match occurs on the device select code, the corresponding device gives an

acknowledgment on Serial Data (SDA) during the 9th bit time. If the device does not match

the device select code, it deselects itself from the bus, and goes into Standby mode.

Table 6.

Operating modes

Mode

RW bit WC(1)

X = VIH or VIL.

Bytes

Initial sequence

Current Address

Read

Start, device select, RW = 1

Random Address

Read

Start, device select, RW = 0, Address

reStart, device select, RW = 1

Sequential Read

≥ 1

Similar to Current or Random Address

Read

Byte Write

VIL

Start, device select, RW = 0

Page Write

VIL

≤ 32 for M24C64

and M24C32

Start, device select, RW = 0

≤ 64 for M24128

M24C64 датащи(PDF) 14 Page - STMicroelectronics

M24C64 датащи(HTML) 14 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

датащи скачать

ссылки URL