TLP558

2007-10-01

2

Absolute Maximum Ratings

(no derating required up to 85°C unless otherwise noted)

Charactersitic

Symbol

Rating

Unit

Forward current

10

mA

Peak transient forward current

(Note 1)

1

A

Reverse voltage

5

V

Output current

40 /

mA

Peak output current

(Note 2)

80 /

mA

Output voltage

V

Supply voltage

V

Three state enabel voltage

V

Output power dissipation

(Note 3)

100

mW

Total package power dissipation

(Note 4)

200

mW

Operating temperature range

°C

Storage temperature range

°C

Lead solder temperature(10s)**

260

°C

Isolation voltage(AC, 1min., R.H.≤ 60%, Ta=25°C)

(Note 5)

2500

Vrms

Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the

significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even

if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum

ratings.

Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook

(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test

report and estimated failure rate, etc).

(Note 1) Pulse width ≤ 1μs, 300pps.

(Note 2) Pulse width ≤ 5μs, duty ratio ≤ 0.025.

(Note 3) Derate 1.8mW / °C above 70°C ambient temperature.

(Note 4) Derate 3.6mW / °C above 70°C ambient temperature.

(Note 5) Device considered a two terminal device: Pins 1, 2, 3 and 4 shorted together, and pins 5, 6, 7 and 8 shorted

together.

**1.6mm below seating plane.

Recommended Operating Conditions

Characteristic

Symbol

Min.

Typ.

Max.

Unit

Input current, on

2*

―

5

mA

Input voltage, off

0

―

0.8

V

Supply voltage

4.5

―

20

V

Enable voltage high

2.0

―

20

V

Enable voltage low

0

―

0.8

V

Fan out(TTL load)

N

―

―

4

―

Operating temperature

―

85

°C

Note: Recommended operating conditions are given as a design guideline to obtain expected performance of the

device. Additionally, each item is an independent guideline respectively. In developing designs using this

product, please confirm specified characteristics shown in this document.

*

2mA condition permits at least 20% CTR degradation guardband.

Initial switching threshold is 1.6mA or less.