CLH02 datasheet(2/5 Pages) TOSHIBA

2 / 5 page

CLH02

2006-11-08

Marking

Abbreviation Code

Part No.

H02

CLH02

Standard Soldering Pad

Handling Precaution

The absolute maximum rating denotes the absolute maximum ratings, which are rated values that must not

be exceeded during operation, even for an instant. The following are the general derating methods that we

recommend for designing a circuit incorporating this device:

VRRM: Use this rating with reference to (1) above. The VRRM has a temperature coefficient of 0.1%/°C.

Take this temperature coefficient into account when designing a device at low temperature.

IF (AV): We recommend that the worst case current be no greater than 80% of the absolute maximum

rating of IF(AV) and that Tj be below 120°C.When using this device, take the margin into

consideration by using an allowable Ta (max)-IF (AV) curve.

IFSM:

This rating specifies the non-repetitive peak current. This applies to abnormal operation only. When using

a device, design a circuit board and a soldering land size to match the appropriate thermal

resistance value.

IFSM:

This rating specifies the non-repetitive peak current. This applies to abnormal operation only, When using

the device, design the circuit board and the soldering land size to match the appropriate thermal

resistance value.

Tj:

Derate this rating when using the device to ensure high reliability. We recommend that the device be

used at a Tj of below 120°C.

The thermal resistance between junction and ambient varies depending on the mounting condition of the

device. When using the device, design the circuit board and the soldering land size to match the appropriate

thermal resistance value.

See the Rectifiers databook for further information.

Unit: mm

2.6

1.8

4.8

5.9

CLH02 датащи(PDF) 2 Page - Toshiba Semiconductor