| поискавой системы для электроныых деталей |
|
TMP88CS38BFG датащи(PDF) 49 Page - Toshiba Semiconductor |
|
|
|||||||||||||||||||||||||||||
TMP88CS38BFG датащи(HTML) 49 Page - Toshiba Semiconductor |
|
49 / 218 page ![]() TMP88CS38B/CM38B/CP38B 2007-09-12 88CS38B-49 2.2.4 Port P5 (P57 to P50) Port P5 is an 8-bit input/output port which can be configured as an input or an output in one-bit unit under software control. Input/output mode is specified by the corresponding bit in the port P5 input/output control register 1 (P5CR1). Port P5 is configured as an input if its corresponding P5CR1 bit is cleared to “0”, and as an output if its corresponding P5CR1 bit is set to “1”. During reset, P5CR1 is initialized to “0”, which configures port P5 as an input. The P5 output latches are also initialized to “1”. Data is written into the output latch regardless of the P5CR1 contents. Therefore initial output data should be written into the output latch before setting P5CR1. Port P5 is also used as is also used as AD converter analog input, a pulse width modulation (PWM) output external interrupt input, timer/counter input, serial bus interface input/output, and an on screen display (OSD) output (I signal). When used as a secondary function input pin except I2C bus interface input/output, the input pins should be set to the input mode. When used as a secondary function output pin except I2C bus interface input/output, the output pins should be set to the output mode and beforehand the output latch should be set to “1”. When P52 and P51 are used as I2C bus interface input/output, P5CR2 bits should be set to the sink open-drain mode, the output latches should be set to “1”, and the output pins should be set to the output mode. When P57 is used as an OSD output pin, the output pin should be set to the output mode and beforehand the port 6 data selection register (PIDS) should be clear to “0”. When used as port P5, the port 6 data selection register (PIDS) should be set to “1”. Note: Input mode port is read the state of input pin. When input/output mode is used mixed, the contents of output latch setting input mode may be changed by executing bit manipulation instructions. |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |