PCA9633DP2 datasheet(21/42 Pages) NXP

21 / 42 page

PCA9633_3

Product data sheet

Rev. 03 — 20 December 2006

21 of 42

NXP Semiconductors

PCA9633

4-bit Fm+ I2C-bus LED driver

Characteristics of the I2C-bus

The I2C-bus is for 2-way, 2-line communication between different ICs or modules. The two

lines are a serial data line (SDA) and a serial clock line (SCL). Both lines must be

connected to a positive supply via a pull-up resistor when connected to the output stages

of a device. Data transfer may be initiated only when the bus is not busy.

8.1 Bit transfer

One data bit is transferred during each clock pulse. The data on the SDA line must remain

stable during the HIGH period of the clock pulse as changes in the data line at this time

will be interpreted as control signals (see Figure 12).

8.1.1 START and STOP conditions

Both data and clock lines remain HIGH when the bus is not busy. A HIGH-to-LOW

transition of the data line while the clock is HIGH is deﬁned as the START condition (S). A

LOW-to-HIGH transition of the data line while the clock is HIGH is deﬁned as the STOP

condition (P) (see Figure 13.)

8.2 System conﬁguration

A device generating a message is a ‘transmitter’; a device receiving is the ‘receiver’. The

device that controls the message is the ‘master’ and the devices which are controlled by

the master are the ‘slaves’ (see Figure 14).

Fig 12. Bit transfer

mba607

data line

stable;

data valid

change

of data

allowed

SDA

SCL

Fig 13. Deﬁnition of START and STOP conditions

mba608

SDA

SCL

STOP condition

SDA

SCL

START condition

PCA9633DP2 датащи(PDF) 21 Page - NXP Semiconductors

PCA9633DP2 датащи(HTML) 21 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42

датащи скачать

ссылки URL