8/13

Axelite Confidential Materials, do not copy or distribute without written consent.

Rev.2.3 Oct.09, 2019

AX3111

Inductor Selection

For most designs, the different frequency can be reducing the inductor value; The

AX3111 is suggested 22µH to 100µH for 350K to 50KHz frequencies. Please refer the

below table to design.

L1 recommend value (VIN=8~40V ,VOUT=5V, IOUT=3A)

Frequency (Hz)

50K

150K

250K

350K

L1 Value (H)

100uH

68uH

33uH

22uH

Where is inductor Ripple Current. Large value inductors lower ripple current and small

value inductors result in high ripple currents. Choose inductor ripple current approximately

20% of the maximum load current 3A, ΔIL=0.6A. The DC current rating of the inductor

should be at least equal to the maximum load current plus half the ripple current to prevent

core saturation (3A+0.3A).

Input Capacitor Selection

This capacitor should be located close to the IC using short leads and the voltage

rating should be approximately 1.5 times the maximum input voltage. The RMS current

rating requirement for the input capacitor of a buck regulator is approximately 1⁄2 the DC

load current. A low ESR input capacitor sized for maximum RMS current must be used. A

470µF low ESR capacitor for most applications is sufficient.

Output Capacitor Selection

The output capacitor is required to filter the output and provide regulator loop stability.

The important capacitor parameters are; the 100 KHz Equivalent Series Resistance (ESR),

the RMS ripples current rating, voltage rating, and capacitance value. For the output

capacitor, the ESR value is the most important parameter. The ESR can be calculated from

the following formula.

ESR

I

V

L

RIPPLE







= 0.6A x 80mΩ= 48mV

An aluminum electrolytic capacitor's ESR value is related to the capacitance and its

voltage rating. In most case, higher voltage electrolytic capacitors have lower ESR values.

Most of the time, capacitors with much higher voltage ratings may be needed to provide

the low ESR values required for low output ripple voltage. It is recommended to replace

this low ESR capacitor by using a 470µF low ESR values < 80mΩ.