RT8101GS datasheet(2/15 Pages) RICHTEK

2 / 15 page

RT8101/A

Preliminary

www.richtek.com

DS8101/A-01 March 2007

Functional Pin Description

BOOT (Pin 1)

Bootstrap supply for the upper gate driver. Connect the

bootstrap capacitor between BOOT pin and the PHASE

pin. The bootstrap capacitor provides the charge to turn

on the upper MOSFET.

UGATE (Pin 2)

Upper gate driver output. Connect to gate of the high-

side power N-Channel MOSFET. This pin is monitored by

the adaptive shoot-through protection circuitry to

determine when the upper MOSFET is turned off.

GND (Pin 3)

Signal ground for the IC.

LGATE (Pin 4)

Lower gate driver output. Connect to the gate of the low-

side power N-Channel MOSFET. This pin is monitored by

the adaptive shoot-through protection circuitry to determine

when the lower MOSFET is turned off.

VCC (Pin 5)

Connect this pin to a well-decoupled 12V bias supply. It

is also the positive supply for the lower gate driver, LGATE.

FB (Pin 6)

Buck converter feedback voltage. This pin is the inverting

input of the error amplifier. FB senses the switcher output

through an external resistor divider network.

COMP (Pin 7)

Buck converter external compensation. This pin is used

to compensate the control loop of the buck converter.

PHASE (Pin 8)

Connect this pin to the source of the upper MOSFET and

the drain of the lower MOSFET. This pin is monitored by

the adaptive shoot-through protection circuitry to

determine when the upper MOSFET is turned off.

Exposed Pad

Exposed pad should be soldered to PCB board and

connected to GND.

Typical Application Circuit

12V

VOUT

CIN

RT8101/A

VIN(+3.3V/+5V/+12V)

PSC

BOOT

VCC

PHASE

UGATE

LGATE

GND

COUT

LOUT

COMP

RBOOT

RUGATE

RT8101GS датащи(PDF) 2 Page - Richtek Technology Corporation

RT8101GS датащи(HTML) 2 Page - Richtek Technology Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

датащи скачать

ссылки URL