1. Slide a rail rod into a rail slide until the rail clip makes an audible click.

The rail clip prevents the extension of the rail beyond the maximum supported distance between the front

and rear rack posts.

Figure 3-6: Assembling the Rails

1

Rail slide

3

Rack plugs

2

Rail rod

4

Rail (assembled)

2. Attach the rail to the right rear rack post by inserting rod-end rack plugs into post slots. The slide assembly

must be on the side of the post facing the router.

If the rack plugs were previously removed, use bolts to attach the rail to the rack.

3. Attach the slide end of the rail to the front post by extending the rail end past the post, then contracting the

rail while guiding the rack plugs into the post.

4. Repeat Step 1 through Step 3 for the left posts. Ensure the rails are on the same horizontal level.

Figure 3-7: Attaching the Rails

1

Inset A

2

Inset B

10