ICS1893CFILFT datasheet(91/126 Pages) ICST

91 / 126 page

Chapter 8 Pin Diagram, Listings, and Descriptions

ICS1893CF, Rev. F, 03/01/07

Mar. 2007

ICS1893CF Data Sheet Rev. F - Release

MDIO

Input/

Output

Management Data Input/Output.

The signal on this pin can be tri-stated and can be driven by one of the

following:

• A Station Management Entity (STA), to transfer command and data

information to the registers of the ICS1893CF.

• The ICS1893CF, to transfer status information.

All transfers and sampling are synchronous with the signal on the MDC

pin.

Note: If the ICS1893CF is to be used in an application that uses the

mechanical MII specification, MDIO must have a 1.5 k

Ω ±5%

pull-up resistor at the ICS1893CF end and a 2 k

Ω ±5% pull-down

resistor at the station management end. (These resistors enable

the station management to determine if the connection is intact.)

RXCLK

Output

Receive Clock.

The ICS1893CF sources the RXCLK to the MAC interface. The

ICS1893CF uses RXCLK to synchronize the signals on the following pins:

RXD[3:0], RXDV, and RXER. The following table contrasts the behavior

on the RXCLK pin when the mode for the ICS1893CF is either 10Base-T

or 100Base-TX.

Note: The signal on the RXCLK pin is conditioned by the RXTRI pin.

Table 8-7. MAC Interface Pins: Media Independent Interface (MII) (Continued)

Name

Number

Type

Pin Description

10Base-T

100Base-TX

The RXCLK frequency is 2.5

MHz.

The RXCLK frequency is 25 MHz.

The ICS1893CF generates its

RXCLK from the MDI data stream

using a digital PLL. When the MDI

data stream terminates, the PLL

continues to operate,

synchronously referenced to the

last packet received.

The ICS1893CF generates its

RXCLK from the MDI data stream

while there is a valid link (that is,

either data or IDLEs). In the

absence of a link, the ICS1893CF

uses the REF_IN clock to

generate the RXCLK.

The ICS1893CF switches

between clock sources during the

period between when its CRS is

asserted and prior to its RXDV

being asserted. While the

ICS1893CF is locking onto the

incoming data stream, a clock

phase change of up to 360

degrees can occur.

While the ICS1893CF is bringing

up a link, a clock phase change of

up to 360 degrees can occur.

The RXCLK aligns once per

packet.

The RXCLK aligns once, when

the link is being established.

ICS1893CFILFT датащи(PDF) 91 Page - Integrated Circuit Systems

ICS1893CFILFT датащи(HTML) 91 Page - Integrated Circuit Systems

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL