DSPIC30F3012AT20ESLASHML datasheet(117/205 Pages) MICROCHIP

117 / 205 page

DS70139E-page 115

dsPIC30F2011/2012/3012/3013

16.13 Configuring Analog Port Pins

The use of the ADPCFG and TRIS registers control the

operation of the A/D port pins. The port pins that are

desired as analog inputs must have their correspond-

ing TRIS bit set (input). If the TRIS bit is cleared (out-

put), the digital output level (VOH or VOL) will be

converted.

The A/D operation is independent of the state of the

CH0SA<3:0>/CH0SB<3:0> bits and the TRIS bits.

When reading the PORT register, all pins configured as

analog input channels will read as cleared.

Pins configured as digital inputs will not convert an ana-

log input. Analog levels on any pin that is defined as a

digital input (including the ANx pins) may cause the

input buffer to consume current that exceeds the

device specifications.

16.14 Connection Considerations

The analog inputs have diodes to VDD and VSS as ESD

protection. This requires that the analog input be

between VDD and VSS. If the input voltage exceeds this

range by greater than 0.3V (either direction), one of the

diodes becomes forward biased and it may damage the

device if the input current specification is exceeded.

An external RC filter is sometimes added for anti-

aliasing of the input signal. The R component should be

selected to ensure that the sampling time requirements

are satisfied. Any external components connected (via

high-impedance) to an analog input pin (capacitor,

zener diode, etc.) should have very little leakage

current at the pin.

DSPIC30F3012AT20E/ML датащи(PDF) 117 Page - Microchip Technology