24LC512-ESLASHP datasheet(5/26 Pages) MICROCHIP

5 / 26 page

DS21754G-page 5

24AA512/24LC512/24FC512

2.0

PIN DESCRIPTIONS

The descriptions of the pins are listed in Table 2-1.

TABLE 2-1:

PIN FUNCTION TABLE

2.1

A0, A1 and A2 Chip Address

Inputs

The A0, A1 and A2 inputs are used by the 24XX512 for

multiple device operations. The logic levels on these

inputs are compared with the corresponding bits in the

slave address. The chip is selected if the compare is

true.

Up to eight devices may be connected to the same bus

by using different Chip Select bit combinations. These

inputs must be connected to either VCC or VSS.

In most applications, the chip address inputs A0, A1

and A2 are hard-wired to logic ‘0’ or logic ‘1’. For

applications in which these pins are controlled by a

microcontroller or other programmable logic device,

the chip address pins must be driven to logic ‘0’ or logic

‘1’ before normal device operation can proceed.

2.2

Serial Data (SDA)

This is a bidirectional pin used to transfer addresses

and data into and data out of the device. It is an open-

drain terminal, therefore, the SDA bus requires a pull-

up resistor to VCC (typical 10 k

Ω for 100 kHz, 2 kΩ for

400kHz and 1MHz).

For normal data transfer, SDA is allowed to change

only during SCL low. Changes during SCL high are

reserved for indicating the Start and Stop conditions.

2.3

Serial Clock (SCL)

This input is used to synchronize the data transfer from

and to the device.

2.4

Write-Protect (WP)

This pin must be connected to either VSS or VCC. If tied

to VSS, write operations are enabled. If tied to VCC,

write operations are inhibited but read operations are

not affected.

3.0

FUNCTIONAL DESCRIPTION

The 24XX512 supports a bidirectional 2-wire bus and

data transmission protocol. A device that sends data

onto the bus is defined as a transmitter and a device

receiving data as a receiver. The bus must be

controlled by a master device which generates the

Serial Clock (SCL), controls the bus access and

generates the Start and Stop conditions, while the

24XX512 works as a slave. Both master and slave

can operate as a transmitter or receiver, but the

master device determines which mode is activated.

Name

PDIP

SOIC

14-lead

TSSOP

DFN

Function

User Configured Chip Select

(NC)

—

3, 4, 5

—

Not Connected

User Configured Chip Select

VSS

Ground

SDA

Serial Data

SCL

Serial Clock

(NC)

—

10, 11, 12

—

Not Connected

Write-Protect Input

VCC

+1.8V to 5.5V (24AA512)

+2.5V to 5.5V (24LC512)

+2.5V to 5.5V (24FC512)

24LC512-E/P датащи(PDF) 5 Page - Microchip Technology

24LC512-E/P датащи(HTML) 5 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26

датащи скачать

ссылки URL