MP1593 – 3A, 28V, 385KHz STEP-DOWN CONVERTER

MP1593 Rev. 1.8

www.MonolithicPower.com

8

1/6/2006

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2006 MPS. All Rights Reserved.

Compensation Components

MP1593 employs current mode control for easy

compensation and fast transient response. The

system stability and transient response are

controlled through the COMP pin. COMP pin is

the output of the internal transconductance

error amplifier. A series capacitor-resistor

combination sets a pole-zero combination to

control the characteristics of the control system.

The DC gain of the voltage feedback loop is

given by:

OUT

FB

VEA

CS

LOAD

VDC

V

V

A

G

R

A

×

×

×

=

400V/V,

is

the

current

sense

resistor value.

The system has two poles of importance. One

is due to the compensation capacitor (C3) and

the output resistor of error amplifier, and the

other is due to the output capacitor and the load

resistor. These poles are located at:

VEA

EA

1

P

A

3

C

2

G

f

×

×

π

=

LOAD

2

P

R

2

C

2

1

f

×

×

π

=

Where

is

the

error

amplifier

transconductance, 800µA/V.

The system has one zero of importance, due to

the compensation capacitor (C3) and the

compensation resistor (R3). This zero is located

at:

3

R

3

C

2

1

Z

×

×

π

=

The system may have another zero of

importance, if the output capacitor has a large

capacitance and/or a high ESR value. The zero,

due to the ESR and capacitance of the output

capacitor, is located at:

ESR

ESR

R

2

C

2

1

f

×

×

π

=

In this case (as shown in Figure 3), a third pole

set by the compensation capacitor (C6) and the

compensation

resistor

(R3)

is

used

to

compensate the effect of the ESR zero on the

loop gain. This pole is located at:

3

R

6

C

2

1

P

×

×

π

=

The goal of compensation design is to shape

the converter transfer function to get a desired

loop gain. The system crossover frequency

where the feedback loop has the unity gain is

important.

Lower crossover frequencies result in slower

line and load transient responses, while higher

crossover frequencies could cause system

unstable. A good rule of thumb is to set the

crossover frequency to approximately one-tenth

of the switching frequency. Switching frequency

for the MP1593 is 385KHz, so the desired

crossover frequency is around 38KHz.

Table 3 lists the typical values of compensation

components for some standard output voltages

with various output capacitors and inductors.

The values of the compensation components

have

been

optimized

for

fast

transient

responses

and

good

stability

at

given

conditions.