Product Bulletin

See Capacitance Value Chart below for thickness dimension.

+ For extended values 1210 case sizes - solder reflow only.

Outline Drawing

W

L

B

S

T

CONDUCTIVE METALLIZATION

ELECTRODES

TIN PLATE

NICKEL PLATE

Surface Mount Ceramic Chip Capacitors – C0G Dielectric

© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 (864) 963-6300 • www.kemet.com

F9126 5/07

EIA SIZE

CODE

METRIC

SIZE CODE

L - LENGTH

W - WIDTH

B - BANDWIDTH

S

SEPARATION

minimum

MOUNTING

TECHNIQUE

0402

1005

1.0 (.04) ± .05 (.002)

0.5 (.02) ± .05 (.002)

0.20 (.008) -.40 (.016)

0.3 (.012)

Solder Reflow

0603

1608

1.6 (.063) ± .15 (.006)

0.8 (.032) ± .15 (.006)

0.35 (.014) ± .15 (.006)

0.7 (.028)

Solder Wave +

or

Solder Reflow

0805

2012

2.0 (.079) ± .20 (.008)

1.25 (.049) ± .20 (.008)

0.50 (.02) ± .25 (.010)

0.75 (.030)

1206

3216

3.2 (.126) ± .20 (.008)

1.6 (.063) ± .20 (.008)

0.50 (.02) ± .25 (.010)

N/A

1210

3225

3.2 (.126) ± .20 (.008)

2.5 (.098) ± .20 (.008)

0.50 (.02) ± .25 (.010)

N/A

Dimensions - Millimeters (Inches)

As detailed in the KEMET Surface Mount Catalog F3102 for C0G, with following specific requirements based on room

temperature (25°C) parameters:

•

Operating Range: -55°C to +125°C, with no-bias capacitance shift limited to ± 30 PPM/°C over that range.

•

Insulation Resistance (IR) measured after 2 minutes at rated voltage @ 25°C: Limit is 1000 megohm microfarads or

100G

Ω, whichever is less.

•

Capacitance and Dissipation Factor (DF) measured at the following conditions.

Capacitance - 1 kHz and 1 vrms if capacitance >1000 pF

1 MHz and 1 vrms if capacitance

≤ 1000 pF

DF Limit is 0.1%.

These components are suitable for wave and reflow soldering. All parts incorporate the standard KEMET

barrier layer of pure nickel, with an overplate of pure tin to provide excellent solderability as well as resist-

ance to leaching.

These chips will be supplied unmarked. However, marking is available as an extra cost option.

AEC-Q200 Rev. C - Automotive

RoHS 6 - 100% tin termination

Electrical Parameters

Soldering Process

Marking

Qualification/Certification