Application information

TS2007

22/29

4

Application information

4.1

Differential configuration principle

The TS2007 is a monolithic fully-differential input/output class D power amplifier. The

TS2007 also includes a common-mode feedback loop that controls the output bias value to

always have a maximum output voltage swing, and by consequence, maximize the output

power. Moreover, as the load is connected differentially compared to a single-ended

topology, the output is four times higher for the same power supply voltage.

The advantages of a full-differential amplifier are:

●

High PSRR (power supply rejection ratio)

●

High common mode noise rejection

●

Virtually zero pop without additional circuitry, giving a faster start-up time compared to

conventional single-ended input amplifiers

●

Easier interfacing with differential output audio DAC

●

No input coupling capacitors required thanks to common mode feedback loop

4.2

Gain settings

In the flat region of the frequency-response curve (no input coupling capacitor or internal

feedback loop + load effect), the differential gain can be set to either 6 or 12 dB depending

on the logic level of the GS pin:

Note:

gain is 6 dB.

4.3

Common mode feedback loop limitations

As explained previously, the common mode feedback loop allows the output DC bias voltage

common mode feedback loop can fulfil its role only within the defined range.

4.4

Low frequency response

If a low frequency bandwidth limitation is required, it is possible to use input coupling

off frequency (see Table 5 to Table 9).

GS

Gain (dB)

Gain (V/V)

1

6dB

2

012dB4