5

AT25FS010

5167B–SFLSH–1/07

Serial Interface

Description

MASTER: The device that generates the serial clock.

SLAVE: Because the Serial Clock pin (SCK) is always an input, the AT25FS010 always

operates as a slave.

TRANSMITTER/RECEIVER: The AT25FS010 has separate pins designated for data

transmission (SO) and reception (SI).

MSB: The Most Significant Bit (MSB) is the first bit transmitted and received.

SERIAL OP-CODE: After the device is selected with CS going low, the first byte will be

received. This byte contains the op-code that defines the operations to be performed.

INVALID OP-CODE: If an invalid op-code is received, no data will be shifted into the

AT25FS010, and the serial output pin (SO) will remain in a high impedance state until

the falling edge of CS is detected again. This will reinitialize the serial communication.

CHIP SELECT: The AT25FS010 is selected when the CS pin is low. When the device is

not selected, data will not be accepted via the SI pin, and the serial output pin (SO) will

remain in a high impedance state.

HOLD: The HOLD pin is used in conjunction with the CS pin to select the AT25FS010.

When the device is selected and a serial sequence is underway, HOLD can be used to

pause the serial communication with the master device without resetting the serial

sequence. To pause, the HOLD pin must be brought low while the SCK pin is low. To

resume serial communication, the HOLD pin is brought high while the SCK pin is low

(SCK may still toggle during HOLD). Inputs to the SI pin will be ignored while the SO pin

is in the high impedance state.

WRITE PROTECT: The AT25FS010 has a write lockout feature that can be activated by

asserting the write protect pin (WP). When the lockout feature is activated, locked-out

sectors will be READ only. The write protect pin will allow normal read/write operations

when held high. When the WP is brought low and WPEN bit is “1”, all write operations to

the status register are inhibited. WP going low while CS is still low will interrupt a write to

the status register. If the internal status register write cycle has already been initiated,

WP going low will have no effect on any write operation to the status register. The WP

pin function is blocked when the WPEN bit in the status register is “0”. This will allow the

user to install the AT25FS010 in a system with the WP pin tied to ground and still be

able to write to the status register. All WP pin functions are enabled when the WPEN bit

is set to “1”.

Operating Features

Recommended Power-

down

power down sequence. This means there should be no write operation/internal Write

cycle or read operation in progress during the Chip Select (CS) line must be allowed to

at ground level for at least 0.5 seconds before power up again.