115

D

L

SW 1

STEGO - PRODUCT CATALOGUE

Part No.

Thread

External thread diameter Cable dia. clamping range D

Hex nut dia.

Torque

Air permeability1

Weight

Size M [mm]

Length L

SW 1

SW 2

Lock nut

Dome nut

28410.0-00

M12 x 1.5

0.31" (8 mm)

0.48" (12.3 mm)

0.16 – 0.28" (4 – 7 mm)

0.74" (19 mm) 0.71" (18 mm)

2 Nm

2 Nm

25 l/h

0.25 oz. (7 g)

28411.0-00

M16 x 1.5

0.39" (10 mm)

0.64" (16.3 mm)

0.16 – 0.28" (4 – 7 mm)

0.74" (19 mm) 0.86" (22 mm)

2 Nm

2 Nm

25 l/h

0.28 oz. (8 g)

28412.0-00

M20 x 1.5

0.39" (10 mm)

0.8" (20.3 mm)

0.24 – 0.44" (6 – 11 mm)

0.94" (24 mm) 1.02" (26 mm)

5 Nm

5 Nm

40 l/h

0.46 oz. (13 g)

1

at a pressure differential of 70 mbar (1 psi)

> Cable gland with integrated ventilation

> High degree of protection

> Easy to install

> Integrated strain relief

> Waterproof filter

> Large clamping range

VENTILATION CABLE GLAND

DAK 284 | IP66 / IP67

ACCESSORIES

Pressure differentials in enclosures with a high degree of protection are a result of internal and external temperature

changes. In the case of negative pressure or partial vacuum, dust and humidity can enter the enclosure through

the door seal. When the air inside the enclosure cools down, condensation may occur because the humidity cannot

escape the enclosure. The innovative and easy-to-install ventilation cable gland DAK 284 enables secure cable

entry into an enclosure with simultaneous pressure compensation (protection type IP66 / IP67). Even with a slight

overpressure, a waterproof filter inside the gland allows the humidity to escape whilst blocking water and dirt

from entering the enclosure.

TECHNICAL DATA

Mounting

thread M12 x 1.5 / M16 x 1.5 / M20 x 1.5

Enclosure wall thickness

0.02 – 0.12" (0.5 – 3 mm) with lock nut

Material

plastic, light grey

Protection type

IP66 / IP67 (EN 60529)

Sealing

sealing gasket NBR

Filter

PTFE

Fitting position

variable

Operating/Storage temperature

-4 to +176 °F (-20 to +80 °C)

Approvals

VDE, UL File No. E471430, EAC

Installation: Make hole cut-out in enclosure and secure ventilation cable gland with lock nut. Please make sure that the sealing

gasket is put in place on the exterior side panel of the enclosure and the hole is free of burrs.