8 / 20

Specifications are subject to changes without notice.

All specifications are typical at 25

C unless otherwise stated

600W Programmable IP67 Driver

EUD-600SxxxDV

Rev. I

www.inventronics-co.com

Tel: 86-571-56565800

Fax: 86-571-86601139

sales@inventronics-co.com

Safety &EMC Compliance

Safety Category

Standard

ENEC & TUV & CE

EN 61347-1, EN 61347-2-13

CB

IEC 61347-1, IEC 61347-2-13

CCC

GB 19510.1, GB 19510.14

PSE

J 61347-1, J 61347-2-13

KC

K 61347-1, K 61347-2-13

BIS

IS 15885(Part2/Sec13)

EAC

ГОСТ Р МЭК 61347-1, ГОСТ IEC 61347-2-13

global-mark

AS/NZS 61347.1, AS/NZS 61347.2.13

EMI Standards

Notes

EN 55015/GB/T 17743/KN 15(1)

Conducted emission Test & Radiated emission Test

EN 61000-3-2/GB 17625.1

Harmonic current emissions

EN 61000-3-3

Voltage fluctuations & flicker

EMS Standards

Notes

EN 61000-4-2

Electrostatic Discharge (ESD): 8 kV air discharge, 4 kV contact discharge

EN 61000-4-3

Radio-Frequency Electromagnetic Field Susceptibility Test-RS

EN 61000-4-4

Electrical Fast Transient / Burst-EFT

EN 61000-4-5

Surge Immunity Test: AC Power Line: Differential Mode 6 kV, Common Mode 10 kV(2)

EN 61000-4-6

Conducted Radio Frequency Disturbances Test-CS

EN 61000-4-8

Power Frequency Magnetic Field Test

EN 61000-4-11

Voltage Dips

EN 61547

Electromagnetic Immunity Requirements Applies To Lighting Equipment

Note: (1) This LED driver meets the EMI specifications above, but EMI performance of a luminaire that contains it depends

also on the other devices connected to the driver and on the fixture itself.

(2) To perform electric strength (hi-pot) testing, the “GDT ground disconnect” (nut and metal lock sheet) on the driver

end-cap should be removed temporarily to prevent the internal gas discharge tube from conducting (as allowed by

IEC 60598-1 Clause 10.2). After testing is completed, these items must be reinstalled to restore line-to-earth surge

protection and secure the end cap.