WM8980_07 datasheet(39/112 Pages) WOLFSON

39 / 112 page

Pre-Production

WM8980

PP Rev 3.1 March 2007

In ALC mode (ALCMODE bit = 0) the circuit aims to keep a constant recording volume irrespective

of the input signal level. This is achieved by continuously adjusting the PGA gain so that the signal

level at the ADC input remains constant. A digital peak detector monitors the ADC output and

changes the PGA gain if necessary.

Figure 20 ALC Operation

The ALC/Limiter function is enabled by setting the register bit ALCSEL. When enabled, the

recording volume can be programmed between –6dB and –28.5dB (relative to ADC full scale) using

the ALCLVL register bits.

An upper limit for the PGA gain can be imposed by setting the

ALCMAXGAIN control bits and a lower limit for the PGA gain can be imposed by setting the

ALCMINGAIN control bits.

ALCHLD, ALCDCY and ALCATK control the hold, decay and attack times, respectively:

Hold

time is the time delay between the peak level detected being below target and the PGA gain

beginning to ramp up. It can be programmed in power-of-two (2n) steps, e.g. 2.67ms, 5.33ms,

10.67ms etc. up to 43.7s. Alternatively, the hold time can also be set to zero. The hold time is not

active in limiter mode (ALCMODE = 1). The hold time only applies to gain ramp-up, there is no delay

before ramping the gain down when the signal level is above target.

Decay

(Gain Ramp-Up) Time is the time that it takes for the PGA gain to ramp up and is given as a

time per gain step, time per 6dB change and time to ramp up over 90% of it’s range. The decay

time can be programmed in power-of-two (2n) steps, from 3.3ms/6dB, 6.6ms/6dB, 13.1ms/6dB, etc.

to 3.36s/6dB.

Attack

(Gain Ramp-Down) Time is the time that it takes for the PGA gain to ramp down and is given

as a time per gain step, time per 6dB change and time to ramp down over 90% of it’s range. The

attack time can be programmed in power-of-two (2n) steps, from 832us/6dB, 1.66ms/6dB,

3.328us/6dB, etc. to 852ms/6dB.

NB, In peak limiter mode the gain control circuit runs approximately 4x faster to allow reduction of

fast peaks. Attack and Decay times for peak limiter mode are given below.

WM8980 датащи(PDF) 39 Page - Wolfson Microelectronics plc