M41T94 datasheet(11/40 Pages) STMICROELECTRONICS

номер детали	M41T94

подробное описание детали	Serial Real Time Clock with 44Bytes NVRAM and Reset

PDF	40 Pages

Scroll/Zoom	100%

производитель	STMICROELECTRONICS [STMicroelectronics]

домашняя страница	http://www.st.com

Logo

11 / 40 page

M41T94

Signal description

11/40

Signal description

2.1

Serial data output (SDO)

The output pin is used to transfer data serially out of the Memory. Data is shifted out on the

falling edge of the serial clock.

2.2

Serial data input (SDI)

The input pin is used to transfer data serially into the device. Instructions, addresses, and

the data to be written, are each received this way. Input is latched on the rising edge of the

serial clock.

2.3

Serial clock (SCL)

The serial clock provides the timing for the serial interface (as shown in Figure 7 on page 13

and Figure 8 on page 14). The W/R bit, addresses, or data are latched, from the input pin,

on the rising edge of the clock input. The output data on the SDO pin changes state after the

falling edge of the clock input.

The M41T94 can be driven by a microcontroller with its SPI peripheral running in either of

the two following modes:

●

(CPOL, CPHA) = ('0', '0') or

●

(CPOL, CPHA) = ('1', '1').

For these two modes, input data (SDI) is latched in by the low-to-high transition of clock

SCL, and output data (SDO) is shifted out on the high-to-low transition of SCL (see Table 2

on page 10 and Figure 6 on page 10).

2.4

Chip Enable (E)

When E is high, the memory device is deselected, and the SDO output pin is held in its high

impedance state. After power-on, a high-to-low transition on E is required prior to the start of

any operation.

M41T94 датащи(PDF) 11 Page - STMicroelectronics