Data Sheet G15972EJ6V0DS

10

μPC4572

RECOMMENDED SOLDERING CONDITIONS

The

μ PC4572 should be soldered and mounted under the following recommended conditions.

For soldering methods and conditions other than those recommended below, contact an NEC Electronics sales

representative.

For technical information, see the following website.

Semiconductor Device Mount Manual (http://www.necel.com/pkg/en/mount/index.html)

Type of Surface Mount Device

μ PC4572G2, 4572G2(5): 8-pin plastic SOP (5.72 mm (225) )

Process

Conditions

Symbol

Infrared Ray Reflow

Peak temperature: 230

°C or below (Package surface temperature),

Reflow time: 30 seconds or less (at 210

°C or higher),

Maximum number of reflow processes: 1 time.

IR30-00-1

Vapor Phase Soldering

Peak temperature: 215

°C or below (Package surface temperature),

Reflow time: 40 seconds or less (at 200

°C or higher),

Maximum number of reflow processes: 1 time.

VP15-00-1

Wave Soldering

Solder temperature: 260

°C or below, Flow time: 10 seconds or less,

Maximum number of flow processes: 1 time,

Pre-heating temperature: 120

°C or below (Package surface temperature).

WS60-00-1

Partial Heating Method

Pin temperature: 300

°C or below,

Heat time: 3 seconds or less (Per each side of the device).

–

Caution Apply only one kind of soldering condition to a device, except for "partial heating method", or the

device will be damaged by heat stress.

Type of Through-hole Device

μ PC4572C, 4572C(5): 8-pin plastic DIP (7.62 mm (300) )

Process

Conditions

Wave Soldering

(only to leads)

Solder temperature: 260

°C or below,

Flow time: 10 seconds or less.

Partial Heating Method

Pin temperature: 300

°C or below,

Heat time: 3 seconds or less (per each lead).

Caution For through-hole device, the wave soldering process must be applied only to leads, and make sure that

the package body does not get jet soldered.

REFERENCE DOCUMENTS

QUALITY GRADES ON NEC SEMICONDUCTOR DEVICES

C11531E

SEMICONDUCTOR DEVICE MOUNT MANUAL

http://www.necel.com/pkg/en/mount/index.html

NEC SEMICONDUCTOR DEVICE RELIABILITY/

QUALITY CONTROL SYSTEM- STANDARD LINEAR IC

IEI-1212

<R>

<R>